A study of hot compression behavior of an as-cast FeCrCuNi2Mn2 high-entropy alloy

被引:16
|
作者
Sajadi, Seyyed Ali [1 ]
Toroghinejad, Mohammad Reza [1 ,2 ]
Rezaeian, Ahmad [1 ]
Ebrahimi, Gholam Reza [3 ]
机构
[1] Isfahan Univ Technol, Dept Mat Engn, Esfahan 8415683111, Iran
[2] Shahid Beheshti Univ, Fac Mech & Energy Engn, Tehran, Iran
[3] Ferdowsi Univ Mashhad, Mat & Met Engn Dept, Mashhad, Razavi Khorasan, Iran
关键词
FeCrCuNi2Mn2 high-entropy alloy; hot compression; Constitutive modeling; dynamic recrystallization; work hardening rate; microstructure; DEFORMATION-BEHAVIOR; DYNAMIC RECRYSTALLIZATION; CONSTITUTIVE ANALYSIS; PROCESSING MAPS; FLOW;
D O I
10.1016/j.jallcom.2021.162732
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
In this study, hot deformation behavior of an as-cast FeCrCuNi2Mn2 high-entropy alloy (HEA) was evaluated. For this purpose, hot compression tests were carried out in the temperature range of 600-1000 degrees C and initial strain rate range of 0.001-0.1 s(-1). Flow stresses under different deformation conditions were then friction-corrected. Work hardening rate analysis was used to evaluate the occurrence of dynamic re crystallization. Microstructures of the hot compressed specimens were characterized using optical microscopy. Strain-dependent constitutive equations were developed using the data obtained from the Sellars-Tegart-Garofalo equation. The critical and peak strain and the critical and peak stress, as dynamic recrystallization parameters, were extracted from the work hardening rate versus stress curves. The results indicated that the modeled flow stresses were generally lower than the measured ones, which could be attributed to the impact of friction on the flow stress. Microstructural observations after hot compression tests as well as evaluation of work hardening rate versus stress curves showed typical dynamic re crystallization characteristics under different deformation conditions. In addition, with increase in deformation temperature and decrease in strain rate, more DRX grains were formed along grain boundaries and shear bands, resulting in a decrease in the flow stress. The size of the DRX grains was strongly affected by deformation temperature and increased with increase in temperature. The normalized critical stress and strain for the initiation of DRX were calculated as epsilon(c)/epsilon(p) = 0.60 and sigma c/sigma p = 0.86, respectively. The activation energy of hot deformation was determined to be 708 kJ/mol. It was noticed that the developed constitutive equations could accurately predict the flow stress behavior of the studied alloy over a wide range of experimental conditions. (C) 2021 Elsevier B.V. All rights reserved.
引用
收藏
页数:15
相关论文
共 50 条
  • [31] Anomalous hot deformation behavior and microstructure evolution of as-cast martensitic NiTi alloy during hot compression
    Chengchuang Tao
    Hongjun Huang
    Ge Zhou
    Bowen Zheng
    Xiaojiao Zuo
    Lijia Chen
    Xiaoguang Yuan
    Journal of Materials Science, 2023, 58 : 7477 - 7492
  • [32] Effect of Zn/Mn on the supercapacitor behavior of high-entropy FeCoNiCrZn/Mn alloy
    Mohanty, Gobinda Chandra
    Gowda, Chinmayee Chowde
    Gakhad, Pooja
    Sanjay, M.
    Singh, Abhishek
    Biswas, Koushik
    Tiwary, Chandra Sekhar
    ENERGY ADVANCES, 2024, 3 (12): : 2972 - 2985
  • [33] Study on the effect of temperature on the microstructure and mechanical properties of as-cast CoCr2Ni3.5VAl1.5Ti high-entropy alloy
    Gao, Yang
    Cai, Yangchuan
    Cui, Yan
    Wang, Kai
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2024, 916
  • [34] Hot compression behaviors and microstructure evolutions of a cast dual-phase NiCoFeCrAl0.7 high-entropy alloy
    Wang, Qiang
    Gao, Tengfei
    Du, Hui
    Hu, Qiang
    Chen, Qiang
    Fan, Zitian
    Zeng, Liangcai
    Liu, Xinwang
    INTERMETALLICS, 2021, 138
  • [35] Hot working of an as-Cast Mg-2%Al alloy
    Kottada, RS
    Chokshi, AH
    THERMEC'2003, PTS 1-5, 2003, 426-4 : 4417 - 4422
  • [36] Room-Temperature Superformability in Novel As-Cast High-Entropy Alloy During Compressive Loading
    Dutta, A.
    Tung, Shu-Yi
    Gupta, Saurabh Kumar
    Tsai, Ming-Hung
    Nene, Saurabh S. S.
    ADVANCED ENGINEERING MATERIALS, 2023, 25 (08)
  • [37] Hot Compression Deformation Behavior of As-cast ZK60-1.0 Er Magnesium Alloy
    Fu Xuedan
    Wang Zhongjun
    Jia Weiping
    RARE METAL MATERIALS AND ENGINEERING, 2017, 46 (10) : 2936 - 2942
  • [38] Effect of Yttrium Addition (0.2%) on the Hot Compression Behavior of the As-cast Mg-Sn Alloy
    Yang, Qiurong
    Zeng, Ying
    Zhou, Mingyang
    Huang, Guanghao
    Ren, Lingbao
    Lu, Jiawei
    Yin, Dongdi
    Jiang, Bin
    Xiyou Jinshu Cailiao Yu Gongcheng/Rare Metal Materials and Engineering, 2019, 48 (07): : 2275 - 2283
  • [39] In situ study on the compression deformation of MoNbTaVW high-entropy alloy
    Zhang, Congyan
    Yue, Binbin
    Bhandari, Uttam
    Starovoytov, Oleg N.
    Yang, Yan
    Young, David P.
    Yan, Jinyuan
    Hong, Fang
    Yang, Shizhong
    JOURNAL OF ALLOYS AND COMPOUNDS, 2021, 871 (871)
  • [40] Constitutive modeling of the hot deformation behavior of CoCrFeMnNi high-entropy alloy
    Brown, Christopher
    McCarthy, Thomas
    Chadha, Kanwal
    Rodrigues, Samuel
    Aranas, Clodualdo, Jr.
    Saha, Gobinda C.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 826