Investigating the removal of ethylbenzene from aqueous solutions using modified graphene oxide: application of response surface methodology

This research focused on the application of response surface methodology (RSM) for the removal of ethylbenzene by the graphene oxide grafted with polymethyl vinyl ketone and aniline (GO-MVK-ANI) from wastewater. The adsorbent was prepared through polymerization of graphene oxide with methyl vinyl ketone using ammonium persulfate initiator and further modification by aniline. The synthesized material was characterized via Fourier transform infrared resonance spectroscopy, scanning electron microscopy, energy-dispersive X-ray spectroscopy and Brunauer-Emmett-Teller analysis. RSM was used to minimize the number of experiments and investigate the effect of three selected parameters (contact time, initial pH and adsorbent dose) on the removal efficiency of ethylbenzene. Additionally, the affecting parameters were optimized based on the selected target (ethylbenzene removal efficiency). The results show that 73% ethylbenzene could be adsorbed with initial ethylbenzene concentration of 20mg/l under the optimum conditions (the contact time of 11min, pH of 5.64 and adsorbent dose of 3.75g/l). In this paper, high R-2-value (97.18%) for ethylbenzene removal and a good agreement with adjusted R-2-value (94.65%) indicated that the model was successful and the results demonstrated a reasonable proportion of the experimental and the predicted results.