CeO2 catalysts with fibrous morphology for soot oxidation: The importance of the soot-catalyst contact conditions

Ceria nanofibers were synthesized as soot oxidation catalysts. In fact, the morphology of the catalyst was tailored to maximize the contact between the soot particles and the catalyst itself, at increasing degrees of soot-catalyst contact. Among the synthesized catalysts, the fibrous shape demonstrated to be most active towards soot oxidation: it reduced the peak combustion temperature from 600 degrees C (non-catalytic combustion) to 375 degrees C in tight contact, 428 degrees C in prolonged loose contact (see detailed definition in the text), and 553 degrees C in loose contact. These results were compared to a very active ceria catalyst obtained with the solution combustion synthesis method, characterized by much higher porosity and SSA surface. It emerged that the nanofibers, although they have one-fifth of the BET of the nanopowders obtained with SCS, they show almost the same activity in tight conditions, and a considerably better one in prolonged loose contact: hence, their peak temperature is 31 degrees C lower than the one of SCS-obtained nanopowders at the latter condition. This encourages to deeply investigate the interaction between the morphology and the real contact-conditions between the catalyst and soot in diesel particulate filters (DPFs), and to tailor the DPF catalytic support to enhance this contact, still maintaining low the pressure drop associated to the catalytic layer. (C) 2013 Elsevier B.V. All rights reserved.