On the reactivity of plasma-treated photo-catalytic TiO2 surfaces for oxidation of C2H2 and CO

The objective of this study is to understand fundamental aspects of interactions of plasmas with catalytic surfaces. Based on this approach the reactivity of plasma treated and stimulated catalytic surfaces of TiO2 is studied by analysing the oxidation (i) of C2H2 to CO and CO2 and (ii) of CO to CO2. The inner surface of a Pyrex discharge tube is coated with TiO2 films impregnated with TiO2 nanoparticles, which provides a surface area of about 4 m(2). In addition to the exposure of the TiO2 surface by low-pressure radio-frequency plasmas using O-2, Ar or N-2 (f = 13.56 MHz, p = 0.53 mbar, P = 17 W) the surfaces are stimulated by heating and UV radiation treatment. The temporal development of the concentrations of the precursor gases C2H2 or CO and of the reaction products is monitored using quantum cascade laser absorption spectroscopy, which provides multi-component detection in the mid-infrared spectral range. The C2H2 concentration was found to be nearly constant over time after a pre-treatment with Ar or N-2 discharges using an initial gas mixture of 1% C2H2 in Ar. However, a strong decay of the concentration of C2H2 is observed for pure O-2 plasma pre-treatment. In general, the decay is found to be nearly exponential with time constant in the order of about 10 min. The reactive adsorption of C2H2 molecules on the inner surface of the tube reactor showed a density of about 7.5 x 10(12) C2H2 molecules cm(-2). This behaviour demonstrates that the reaction (O-ads + C2H2)(TiO2) produces some adsorbed intermediates, which can be thermally or photo-catalytically oxidized to CO2. In contrast, when 1% CO in Ar is used as an initial gas mixture no adsorption processes on the TiO2 surface could be detected. An effective destruction of CO took part via photo-catalytic oxidation.