Experimental optimization of the impact energy absorption of epoxy-carbon laminates through controlled delamination

被引:40
|
作者
Pegoretti, Alessandro [1 ]
Cristelli, Ivan
Migliaresi, Claudio
机构
[1] Univ Trent, Dept Mat Engn & Ind Technol, I-38100 Trento, Italy
关键词
Layered structures; Impact behaviour; Delamination; Fracture toughness; Interleaving;
D O I
10.1016/j.compscitech.2008.04.036
中图分类号
TB33 [复合材料];
学科分类号
摘要
In this paper, the correlation between interlaminar fracture toughness and impact energy absorption for the fracture of epoxy-carbon laminates was studied. Carbon fibres-epoxy cross-ply prepreg layers were interleaved with thin (26 pm) poly(ethylene-terephthalate) (PET) films. Before the composite preparation, circular holes I mm in diameter were drilled in the PET films at several densities (from 0 up to 44 holes/cm(2)) in order to selectively increase the interlaminar contact area between the epoxy-carbon laminae. In this way, the interlaminar contact area was gradually varied from 0%, corresponding to the case in which non-perforated PET films were used, up to 100% in the case of non-interleaved laminates. The Mode I interlaminar fracture toughness of the resulting laminates was determined according to the ASTM D-5528-01 standard test method on double cantilever beam (DCB) specimens. The critical values of the strain energy release rate determined at the point at which the load versus opening displacement curve becomes non-linear (G(IC,NL)) resulted to vary from 40 up to 260 J/m(2), depending on the interlaminar contact area. All the laminates were then characterized by three point bending tests performed both under quasi-static (5 mm/min) and impact (2 m/s) loading conditions. The elastic modulus of the laminates resulted to be practically independent of the level of interlaminar adhesion, while the bending strength decreased as the interlaminar fracture toughness decreased. The total energy to fracture evaluated under impact conditions showed a non-monotonic correlation with the interlaminar fracture toughness, reaching a maximum level in correspondence of a G(IC,NL) value of about 60 J/m(2). At the same time, the ductility index, i.e. the ratio between the propagation and the initiation energies, evaluated by instrumented Charpy impact tests, markedly increased as the interlaminar fracture toughness decreased. (c) 2008 Elsevier Ltd. All rights reserved.
引用
收藏
页码:2653 / 2662
页数:10
相关论文
共 50 条
  • [21] Experimental determination of elastic properties of impact damage in carbon fibre/epoxy laminates
    Sjögren, A
    Krasnikovs, A
    Varna, J
    COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING, 2001, 32 (09) : 1237 - 1242
  • [22] Research on the Damage Assessment of Carbon/Epoxy Composite Laminates at Different Impact Energy
    Zhang, Aying
    Lu, Haibao
    PROCEEDINGS OF THE 2015 INTERNATIONAL SYMPOSIUM ON MATERIAL, ENERGY AND ENVIRONMENT ENGINEERING (ISM3E 2015), 2016, 46 : 35 - 38
  • [23] Low energy impact performance of interleaved carbon fibre reinforced epoxy laminates
    Yuan, Q
    Karger-Kocsis, J
    Ye, L
    ADVANCED COMPOSITES LETTERS, 2000, 9 (06) : 423 - 430
  • [24] Optimizing energy absorption in multi-layered materials through controlled delamination
    M. H. Lear
    B. V. Sankar
    Journal of Materials Science, 1999, 34 : 4181 - 4191
  • [25] Optimizing energy absorption in multi-layered materials through controlled delamination
    Lear, MH
    Sankar, BV
    JOURNAL OF MATERIALS SCIENCE, 1999, 34 (17) : 4181 - 4191
  • [26] Energy absorption capability of nanomodified glass/epoxy laminates
    Aymerich, F.
    Dalla Via, A.
    Quaresimin, M.
    11TH INTERNATIONAL CONFERENCE ON THE MECHANICAL BEHAVIOR OF MATERIALS (ICM11), 2011, 10
  • [27] Modelling the interaction between matrix cracking and delamination in carbon-epoxy laminates under low velocity impact
    de Moura, MFSF
    Gonçalves, JPM
    COMPOSITES SCIENCE AND TECHNOLOGY, 2004, 64 (7-8) : 1021 - 1027
  • [28] Graphene/epoxy interleaves for delamination toughening and monitoring of crack damage in carbon fibre/epoxy composite laminates
    Du, Xusheng
    Zhou, Helezi
    Sun, Weifu
    Liu, Hong-Yuan
    Zhou, Guangnan
    Zhou, Huamin
    Mai, Yiu-Wing
    COMPOSITES SCIENCE AND TECHNOLOGY, 2017, 140 : 123 - 133
  • [29] Influence of Delamination Characteristics in Carbon Fibre/Epoxy Laminates on Signal Features of Pulse Thermography
    Schmutzler, Henrik
    Garcia, Alejandro
    Sato, Narumichi
    Wittich, Hans
    Nishikawa, Masaaki
    Rohling, Hermann
    Hojo, Masaki
    Schulte, Karl
    Fiedler, Bodo
    JOURNAL OF NONDESTRUCTIVE EVALUATION, 2015, 34 (01)
  • [30] Influence of Delamination Characteristics in Carbon Fibre/Epoxy Laminates on Signal Features of Pulse Thermography
    Henrik Schmutzler
    Alejandro Garcia
    Narumichi Sato
    Hans Wittich
    Masaaki Nishikawa
    Hermann Rohling
    Masaki Hojo
    Karl Schulte
    Bodo Fiedler
    Journal of Nondestructive Evaluation, 2015, 34