Flow and heat transfer characteristics of r22 and ethanol at supercritical pressures

被引:36
|
作者
Jiang, Pei-Xue [1 ]
Zhao, Chen-Ru [1 ,2 ]
Liu, Bo [1 ]
机构
[1] Tsinghua Univ, Beijing Key Lab Utilizat & Reduct Technol CO2, Key Lab Thermal Sci & Power Engn, Minist Educ,Dept Thermal Engn, Beijing 100084, Peoples R China
[2] Tsinghua Univ, Inst Nucl & New Energy Technol, Beijing 100084, Peoples R China
来源
基金
中国国家自然科学基金;
关键词
Supercritical pressures; R22; Ethanol; Frictional pressure drop; Convection heat transfer; CONVECTION; CO2; DETERIORATION; WATER;
D O I
10.1016/j.supflu.2012.06.011
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
This paper presents an experimental investigation of the flow and convection heat transfer characteristics of R22 and ethanol at supercritical pressures in a vertical small tube with an inner diameter of 1.004 mm. The heat flux ranges from 1.1 x 10(5) W m(-2) to 1.8 x 10(6) W m(-2), the fluid inlet Reynolds number ranges from 3.5 x 10(3) to 2.4 x 10(4), and the pressure ranges from 5.5 MPa to 10 MPa. The results show that for supercritical R22, the frictional pressure drop increases significantly with the heat flux. At p = 5.5 MPa, Re-in = 12,000 and a heat flux of 10(6) W m(-2), the local heat transfer is greatly reduced due to the low density fluid near the high temperature wall. Both buoyancy and flow acceleration have little effect on the heat transfer. For supercritical ethanol, the frictional pressure drop variation with the heat flux is insignificant, while the local heat transfer coefficient increases as the enthalpy increases. Ethanol gives better flow and heat transfer performance than R22 at supercritical pressures from 7.3 M Pa to 10 MPa for heat fluxes of 1.1 x 10(5)-1.8 x 10(6) W m(-2). (C) 2012 Elsevier B.V. All rights reserved.
引用
收藏
页码:75 / 89
页数:15
相关论文
共 50 条
  • [11] Experimental investigation on condensation heat transfer of R22 and R410a in microtubes
    Zhang, Huiyong
    Li, Junming
    Wang, Buxuan
    Jixie Gongcheng Xuebao/Chinese Journal of Mechanical Engineering, 2008, 44 (03): : 70 - 74
  • [12] Flow and pressure drop characteristics of R22 in adiabatic capillary tubes
    Sung Goo Kim
    Min Soo Kim
    Sung Tack Ro
    Baek Youn
    KSME International Journal, 2001, 15 : 1328 - 1338
  • [13] Flow and pressure drop characteristics of r22 in adiabatic capillary tubes
    Kim, SG
    Kim, MS
    Ro, ST
    Youn, B
    KSME INTERNATIONAL JOURNAL, 2001, 15 (09): : 1328 - 1338
  • [14] Heat transfer characteristics of carbon dioxide cross flow over tube bundles at supercritical pressures
    Gao, Weikai
    Zhao, Jiaqing
    Li, Xiaowei
    Zhao, Houjian
    Zhang, Yiyang
    Wu, Xinxin
    APPLIED THERMAL ENGINEERING, 2019, 158
  • [15] Heat transfer and pressure drop during condensation of R22 in microfin tubes
    Wang, XL
    Wu, XM
    Wang, WC
    Lu, HL
    ENERGY AND ENVIRONMENT, VOLS 1 AND 2, 2003, : 833 - 836
  • [16] Heat transfer with refrigerant R22 boiling in horizontal smooth and finned tubes
    Rifert, VG
    Gorin, VV
    Ozimay, SS
    Zolotuhin, IV
    HEAT TRANSFER 1998, VOL 2: GENERAL PAPERS, 1998, : 345 - 350
  • [17] Flow condensing heat transfer of R410A, R22, and R32 inside a micro-fin tube
    Quang Vu Pham
    Choi, Kwang-Il
    Oh, Jong-Taek
    Cho, Honggi
    EXPERIMENTAL HEAT TRANSFER, 2019, 32 (02) : 102 - 115
  • [18] CYCLE ANALYSIS AND HEAT-TRANSFER CHARACTERISTICS OF A HEAT-PUMP USING R22/R142B REFRIGERANT MIXTURES
    KIM, TS
    SHIN, JY
    KIM, MS
    RO, ST
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 1994, 17 (06): : 391 - 399
  • [19] Condensation heat transfer of R22 and R410A in horizontal smooth and microfin tubes
    Kim, MH
    Shin, JS
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2005, 28 (06): : 949 - 957
  • [20] Evaporating heat transfer of R22 and R410A in horizontal smooth and microtin tubes
    Kim, MH
    Shin, JS
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2005, 28 (06): : 940 - 948