Copper Deposition from Its Sulfate Solution onto Titanium Powder with the Simultaneous Mechanical Activation of the Mixture

被引:1
|
作者
Vadchenko, S. G. [1 ]
Suvorova, E. V. [1 ]
Mukhina, N. I. [1 ]
Kovalev, I. D. [1 ]
机构
[1] Russian Acad Sci, Inst Struct Macrokinet, Chernogolovka 142432, Moscow Oblast, Russia
基金
俄罗斯基础研究基金会;
关键词
copper deposition; mechanical activation; sintering; titanium-copper intermetallic compounds; BULK METALLIC GLASSES; TI; ALLOY; ZR; SYSTEM;
D O I
10.3103/S1067821220050144
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
To fabricate Cu-Ti composite particles, the method of copper deposition from its sulfate solution on titanium powder particles with the simultaneous mechanical activation (MA) of the mixture in an AGO-2 planetary ball mill for 5 min is used. The CuSO4. 5H(2)O concentration in solutions is 10 and 16%, which provides molar ratio Cu/Ti = 0.85 and 1.36, respectively, with the complete reduction of copper. The rapid reduction of copper in the form of highly dispersed partially amorphized powder occurs during MA, and composite particles with a thin laminate structure and high reaction ability are formed. Prepared composites are rinsed and stored in argon because reduced copper possesses high activity and rapidly oxidizes in air to oxide Cu2O. After drying, the additional MA of the mixture is performed for 5 min. Pellets 3 mm in diameter and up to 1.5 mm in height are compacted from prepared powders and heated in argon to 700-1200 degrees C. An intense reaction with heat liberation (heat explosion) and the formation of TiCu, Ti2Cu3, and Ti2Cu intermetallic compounds starts upon sample heating. The critical inflammation temperature for composite powders formed by MA with simultaneous copper deposition from the solution is 480 degrees C, which is 400 degrees C below the inflammation temperature of the usual powder mixture of titanium and copper. The alloy has a dendritic structure at a heating temperature close to the melting point, while, if it is exceeded by more than 100 degrees C, the phase distribution in the alloys becomes more uniform and their size decreases.
引用
收藏
页码:534 / 539
页数:6
相关论文
共 41 条