Vortex-induced vibration;
Cylinder near a plane boundary;
Steady flow;
Vortex shedding;
VERY-LOW MASS;
CIRCULAR-CYLINDER;
FLUID FORCES;
CROSS-FLOW;
DYNAMICS;
MODEL;
D O I:
10.1007/s10409-008-0221-7
中图分类号:
TH [机械、仪表工业];
学科分类号:
0802 ;
摘要:
In this study, the vortex-induced vibrations of a cylinder near a rigid plane boundary in a steady flow are studied experimentally. The phenomenon of vortex-induced vibrations of the cylinder near the rigid plane boundary is reproduced in the flume. The vortex shedding frequency and mode are also measured by the methods of hot film velocimeter and hydrogen bubbles. A parametric study is carried out to investigate the influences of reduced velocity, gap-to-diameter ratio, stability parameter and mass ratio on the amplitude and frequency responses of the cylinder. Experimental results indicate: (1) the Strouhal number (St) is around 0.2 for the stationary cylinder near a plane boundary in the sub-critical flow regime; (2) with increasing gap-to-diameter ratio (e (0)/D), the amplitude ratio (A/D) gets larger but frequency ratio (f/f (n) ) has a slight variation for the case of larger values of e (0)/D (e (0)/D > 0.66 in this study); (3) there is a clear difference of amplitude and frequency responses of the cylinder between the larger gap-to-diameter ratios (e (0)/D > 0.66) and the smaller ones (e (0)/D < 0.3); (4) the vibration of the cylinder is easier to occur and the range of vibration in terms of V (r) number becomes more extensive with decrease of the stability parameter, but the frequency response is affected slightly by the stability parameter; (5) with decreasing mass ratio, the width of the lock-in ranges in terms of V (r) and the frequency ratio (f/f (n) ) become larger.
机构:
Hong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R ChinaHong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R China
Zhou, CY
So, RMC
论文数: 0引用数: 0
h-index: 0
机构:
Hong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R ChinaHong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R China
So, RMC
Lam, K
论文数: 0引用数: 0
h-index: 0
机构:
Hong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R ChinaHong Kong Polytech Univ, Dept Mech Engn, Kowloon, Hung Hom, Peoples R China
机构:
Univ Teknol Malaysia, Fac Mech Engn, Dept Aeronaut Automot & Ocean Engn, Johor Baharu, MalaysiaUniv Teknol Malaysia, Fac Mech Engn, Dept Aeronaut Automot & Ocean Engn, Johor Baharu, Malaysia
Shaharuddin, N. M. R.
Darus, I. Z. Mat
论文数: 0引用数: 0
h-index: 0
机构:
Univ Teknol Malaysia, Fac Mech Engn, Dept Appl Mech & Design, Johor Baharu, MalaysiaUniv Teknol Malaysia, Fac Mech Engn, Dept Aeronaut Automot & Ocean Engn, Johor Baharu, Malaysia