Improved modulation of two-stage matrix converter for EMA in aircraft applications

被引:0
|
作者
Xiao, Kun [1 ]
Wang, Lina [1 ]
Wheeler, Pat
机构
[1] Beihang Univ, Sch Automat Sci & Elect Engn, BUAA, Beijing, Peoples R China
关键词
Matrix converter; Modulation strategy; Pulse Width Modulation (PWM); Adjustable speed control; Actuator;
D O I
暂无
中图分类号
TM [电工技术]; TN [电子技术、通信技术];
学科分类号
0808 ; 0809 ;
摘要
This paper presents the improved modulation strategy of Two-Stage Matrix Converter (TSMC) for applications in aircraft Electro-Mechanical Actuator (EMA) system. In the modulation of rectifier stage, Phase Locked Loop (PLL) is employed to track the instantaneous value of both the angle and the frequency of the input voltage vector. The frequency is then taken into calculation to compensate the angle sample delay, as a result of the un-ignorable angle alternation in each Pulse Width Modulation (PWM) cycle at input frequency of 360 similar to 800Hz. The drawbacks of the sample delay are discussed, which lie in the incorrect input power factor control, fluctuation of voltage transfer ratio and possibility of short circuit in inverter stage. In the modulation of inverter stage, a 4-time commutation PWM pattern is presented, which reduces the number of commutations from 6 to 4 in each PWM cycle. Therefore, increasing the PWM frequency by 50% remains the same number of commutations thus the same switching loss per time interval. The sample delay and the output current harmonic could be reduced thereafter at the increased PWM frequency. Simulation and experiment results verify the improved performance of the proposed modulation.
引用
收藏
页数:9
相关论文
共 50 条
  • [21] Selecting the Carrier Frequency for Two-Stage Matrix Converter Based on dual space vector and dual carrier modulation
    Du Shaowu
    Yi Zhang
    Xiangzhi Meng
    Anming Zhong
    IEEE PEDG 2010: THE 2ND INTERNATIONAL SYMPOSIUM ON POWER ELECTRONICS FOR DISTRIBUTED GENERATION SYSTEMS, 2010, : 129 - 132
  • [22] A Multi-Drive System Based on a Two-stage Matrix Converter
    Kumar, Dinesh
    Wheeler, Patrick W.
    Clare, Jon C.
    Empringham, Lee
    2008 13TH INTERNATIONAL POWER ELECTRONICS AND MOTION CONTROL CONFERENCE, VOLS 1-5, 2008, : 207 - 212
  • [23] Control of Two-stage Matrix Converter under Unbalanced Source Voltages
    Li, Gang
    Yu, Shengbao
    Lin, Jun
    2016 IEEE TRANSPORTATION ELECTRIFICATION CONFERENCE AND EXPO, ASIA-PACIFIC (ITEC ASIA-PACIFIC), 2016, : 267 - 271
  • [24] A two-stage nonhomogeneous Poisson process model with applications to aircraft safety
    Pham, H
    Xie, MG
    SEVENTH ISSAT INTERNATIONAL CONFERENCE ON RELIABILITY AND QUALITY IN DESIGN, 2002, : 151 - 156
  • [25] A two-stage sodium converter coupled to a two-stage TEG: Parametric optimization
    Peng, Wanli
    Gonzalez-Ayala, Julian
    Guo, Juncheng
    Dong, Jucan
    Qin, Qi
    APPLIED THERMAL ENGINEERING, 2023, 229
  • [26] Hybrid Modulation Strategy for Two-Stage Matrix Converter and its Application in Vector Control of Doubly Fed Induction Generator
    Li, Danyun
    Shen, Quntai
    Liu, Zhentao
    Liu, Fang
    JOURNAL OF ADVANCED COMPUTATIONAL INTELLIGENCE AND INTELLIGENT INFORMATICS, 2016, 20 (01) : 171 - 180
  • [27] Two-Stage Matrix Converter Based on Third-Harmonic Injection Technique
    Wang, Hui
    Su, Mei
    Sun, Yao
    Yang, Jian
    Zhang, Guanguan
    Gui, Weihua
    Feng, Jianghua
    IEEE TRANSACTIONS ON POWER ELECTRONICS, 2016, 31 (01) : 533 - 547
  • [28] Control strategy of two-stage matrix converter under input voltages sag
    Li, Gang
    Sun, Kai
    Huang, Li-Pei
    Dianji yu Kongzhi Xuebao/Electric Machines and Control, 2009, 13 (01): : 1 - 5
  • [29] Closed-control of two-stage matrix converter based on compound controller
    School of Information Science and Engineering, Central South University, Changsha 410083, China
    不详
    Zhongnan Daxue Xuebao (Ziran Kexue Ban), 2007, 6 (1179-1185): : 1179 - 1185
  • [30] Indirect Torque Control of Induction Motor Based on Two-Stage Matrix Converter
    Su Mei
    Xie HongJun
    2008 7TH WORLD CONGRESS ON INTELLIGENT CONTROL AND AUTOMATION, VOLS 1-23, 2008, : 8591 - 8594