Experimental and finite element investigation on wrinkling behaviour in deep drawing process of A13105/Polypropylene/Stee1304 sandwich sheets

被引：15

作者：

Atrian, Amir ^{[1
]}

Panahi, Hamed ^{[1
]}

机构：

[1] Islamic Azad Univ, Dept Mech Engn, Najafabad Branch, Najafabad, Iran

来源：

PROCEEDINGS OF THE 17TH INTERNATIONAL CONFERENCE ON METAL FORMING METAL FORMING 2018 | 2018年 / 15卷

关键词：

Sandwich sheet; Deep drawing; Wrinkling; Finite element;

D O I：

10.1016/j.promfg.2018.07.396

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The three-layer aluminum 3105 polypropylene 304 steel components are fabricated using the deep drawing process. Then, finite element (FE) simulation of this process was carried out in ABAQUS software and the results of numerical and experimental studies regarding the effects of blank holder force on wrinkling of blank's flange and punch force were compared to each other. The results indicate a reduction in wrinkling of the deep drawn cups with increase in BHF. In addition, FE simulation could predict the tearing place in the samples well. (C) 2018 The Authors. Published by Elsevier B.V. Peer-review under responsibility of the scientific committee of the 17th International Conference on Metal Forming.

引用

页码：984 / 991

页数：8

共 32 条

[31] Finite element modelling and experimental investigation of single point incremental forming process of aluminum sheets: influence of process parameters on punch force monitoring and on mechanical and geometrical quality of parts
H. Arfa
R. Bahloul
H. BelHadjSalah
International Journal of Material Forming, 2013, 6 : 483 - 510
[32] Experimental and numerical investigation to determine the optimal blank-holder force in deep drawing process based on forming force for SS304L and St14 sheets
Asgharpour, Aliakbar
Gorji, Hamid
Delpazir, Seyed Ehsan
JOURNAL OF THE BRAZILIAN SOCIETY OF MECHANICAL SCIENCES AND ENGINEERING, 2024, 46 (06)

← 1 2 3 4 →