Industrial test of a 6-m long bearing steel ingot by electroslag remelting withdrawing process

被引：0

作者：

Zang, Xi-min ^{[1
]}

Qiu, Tian-yu ^{[1
]}

Deng, Xin ^{[1
]}

Jiang, Zhou-hua ^{[2
]}

Li, Hua-bing ^{[2
]}

机构：

[1] Univ Sci & Technol Liaoning, Sch Met & Mat, Anshan 114051, Liaoning, Peoples R China

[2] Northeastern Univ, Sch Met & Mat, Shenyang 110004, Peoples R China

来源：

CHINA FOUNDRY | 2015年 / 12卷 / 03期

基金：

中国国家自然科学基金;

关键词：

electroslag remelting withdrawing; bifilar mode; slag leakage and steel leakage; slag physicochemical properties; ingot solidification shrinkage; MOLD;

D O I：

暂无

中图分类号：

TF [冶金工业];

学科分类号：

0806 ;

摘要：

In this study, the key technologies of a 6-m long bearing steel ingot produced by electroslag remelting withdrawing (ESRW) process, including bifilar mode supply, slag system development, and design of mold, were studied based on the laboratory research achievements. The 6-m long ingot of bearing steel GGr15 with a cross-section of 300 mm x 340 mm was produced using the ESRW process with a bifilar mode and a multi-taper T-mold in a plant. The testing results show that the melting rate using the ESRW bifilar mode technology is three times faster than traditional electroslag remelting (ESR), and the power consumption is only 1,320 kWh per ton steel. Through testing for the chemical composition, macrostructure and inclusions of remelted ingot, it can be concluded that the ESRW bifilar mode technology not only retains the characteristics of traditional ESR, but also improves the production efficiency and reduces the cost compared to traditional ESR.

引用

页码：202 / 207

页数：6