Power loss analysis of active clamp forward converter in continuous conduction mode and discontinuous conduction mode operating modes

被引：14
|
作者：
Xu, Shen [1 ]
Zhang, Taizhi [1 ]
Yao, Yunpeng [1 ]
Sun, Weifeng [1 ]
机构：
[1] Southeast Univ, Natl ASIC Syst Engn Res Ctr, Nanjing 210096, Jiangsu, Peoples R China
来源：
IET POWER ELECTRONICS | 2013年 / 6卷 / 06期
关键词：
EFFICIENCY; DESIGN;
D O I：
10.1049/iet-pel.2013.0019
中图分类号：
TM [电工技术]; TN [电子技术、通信技术];
学科分类号：
0808 ; 0809 ;
摘要：
In order to improve the light-load efficiency of active clamp forward converter with synchronous rectifier (SR), power loss analysis of the converter operating in continuous conduction mode (CCM) and discontinuous conduction mode (DCM) are presented in this study. The light-load efficiency of normal ACF converter with SR is low because the output inductor current can go negative when operating in CCM. Considering the fixed frequency control only, to shift the converter's operating mode from CCM to DCM at a critical point of output current at light-load is a solution for efficiency improvement. Based on the CCM and DCM power dissipation models proposed in this study, the power loss characteristics of the converter are analysed, and the critical shift point of output current can be derived, which has also been verified by an experimental prototype.
引用
收藏
页码：1142 / 1150
页数：9
相关论文
共 50 条
  • [41] ANALYSIS AND DESIGN OF A THREE-PHASE HIGH POWER FACTOR RECTIFIER BASED ON THE SEPIC CONVERTER OPERATING IN DISCONTINUOUS CONDUCTION MODE
    Tibola, Gabriel
    Barbi, Ivo
    XI BRAZILIAN POWER ELECTRONICS CONFERENCE (COBEP 2011), 2011, : 26 - 31
  • [42] Unified model of boost converter in continuous and discontinuous conduction modes
    Han, Junfeng
    Zhang, Bo
    Qiu, Dongyuan
    IET POWER ELECTRONICS, 2016, 9 (10) : 2036 - 2043
  • [43] ANALYSIS OF OUTPUT VOLTAGE RIPPLE FOR DUAL RANDOMIZED PWM BUCK CONVERTER OPERATING IN CONTINUOUS AND DISCONTINUOUS CONDUCTION MODES
    BOUDOUDA, A. I. M. A. D.
    BOUDJERDA, N. A. S. S. E. R. D. I. N. E.
    NAFA, F. A. R. E. S.
    ACTA POLYTECHNICA, 2022, 62 (02) : 262 - 273
  • [44] Sliding mode control of boost rectifiers operating in discontinuous conduction mode for small wind power generators
    Bendaoud, Mohamed
    WIND ENGINEERING, 2022, 46 (03) : 938 - 948
  • [45] Digital control of boost PFC converters operating in both continuous and discontinuous conduction mode
    De Gussemé, K
    Van de Sype, DM
    Van den Bossche, AP
    Melkebeek, JA
    PESC 04: 2004 IEEE 35TH ANNUAL POWER ELECTRONICS SPECIALISTS CONFERENCE, VOLS 1-6, CONFERENCE PROCEEDINGS, 2004, : 2346 - 2352
  • [46] Harmonic winding loss in buck DC-DC converter for discontinuous conduction mode
    Murthy-Bellur, D.
    Kazimierczuk, M. K.
    IET POWER ELECTRONICS, 2010, 3 (05) : 740 - 754
  • [47] Hysteresis Switching Control of the Cuk Converter Operating in Discontinuous Conduction Modes
    Lekic, Aleksandra
    Stipanovic, Dusan M.
    IEEE TRANSACTIONS ON CIRCUITS AND SYSTEMS II-EXPRESS BRIEFS, 2017, 64 (09) : 1077 - 1081
  • [48] Digitally controlled boost power-factor-correction converters operating in both continuous and discontinuous conduction mode
    De Gussemé, K
    Van de Sype, DM
    Van den Bossche, APM
    Melkebeek, JA
    IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, 2005, 52 (01) : 88 - 97
  • [49] Analysis of Output Voltage of Switching Frequency Modulated DC-DC Converter Operating in Discontinuous Conduction Mode
    Stepins, Deniss
    IEEE INTERNATIONAL SYMPOSIUM ON INDUSTRIAL ELECTRONICS (ISIE 2010), 2010, : 670 - 675
  • [50] An adaptive sliding mode controller for buck converter in continuous conduction mode
    Tan, SC
    Lai, YM
    Tse, CK
    Cheung, MKH
    APEC 2004: NINETEENTH ANNUAL IEEE APPLIED POWER ELECTRONICS CONFERENCE AND EXPOSITION, VOLS 1-3, 2004, : 1395 - 1400
12345