Investigation of stress-strain behavior of a sheet material using free bulging test

In this work, a new experimental-numerical technique is developed in order to investigate the constitutive behaviour of a sheet material in conditions of superplastic forming. The principal feature of this technique is that unlike classical tensile testing it allows one to obtain stress-strain curves for a material formed in biaxial tension conditions produced by free bulging process. These conditions are much closer to the ones that the material undergoes during the superplastic forming process. Consequently, they give more accurate information about the material behaviour than the ones coming from tensile tests data. The drawback is that the strain (and similarly its time derivative) cannot be directly measured and controlled during free bulging test but its value has to be derived from other macroscopic measurement. Towards this end, a blow forming machine was equipped with a position transducer for the measurement of the dome height during the test. In order to control the stress in the dome apex at a predetermined level the applied pressure was continuously adjusted to current dome height using a special algorithm. After the test, the dome height data were processed to obtain the evolution of stress, strain and strain rate at the dome apex as well as the stress strain curves for constant referenced strain rates. The tests were performed on superplastic aluminium alloy (ALNOVI-U) sheets of 1.35 mm initial thickness at 500 C. Using the data from two tests with different strain rate paths the stress -strain curves and the strain rate sensitivity index evolution were calculated for two constant referenced strain rates. The obtained constitutive data were verified by finite element simulation of a blow forming. (C) 2017 The Authors. Published by Elsevier Ltd.