Texture evolution in an electrodeposited nanocrystalline Ni-Fe alloy during growth-plane rolling and cross-section rolling

被引：9
|
作者：
Yang, Y. L. [2 ]
Chen, J. G. [3 ]
Lu, D. P. [2 ]
Liu, K. M. [2 ]
Zou, J. [2 ]
Ungar, T. [4 ]
Wang, Y. D. [1 ]
机构：
[1] Beijing Inst Technol, Sch Mat Sci & Engn, Beijing 100081, Peoples R China
[2] Jiangxi Acad Sci, Jiangxi Key Lab Adv Copper & Tungsten Mat, Nanchang 330029, Jiangxi, Peoples R China
[3] Northeastern Univ, Minist Educ, Key Lab Electromagnet Proc Mat, Liaoning Shenyang 110004, Peoples R China
[4] Eotvos Lorand Univ, Dept Mat Phys, H-1518 Budapest, Hungary
来源：
SCRIPTA MATERIALIA | 2012年 / 67卷 / 05期
基金：
中国国家自然科学基金;
关键词：
Nanocrystalline; Nickel-iron alloy; Cold rolling; Grain growth; Texture; ROOM-TEMPERATURE; GRAIN-SIZE; NICKEL; DEFORMATION; COPPER; MICROSTRUCTURE;
D O I：
10.1016/j.scriptamat.2012.06.012
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
Texture evolution in an electrodeposited nanocrystalline Ni-Fe alloy upon cold-rolling has been investigated by X-ray diffraction. In particular, the cold-rolling was performed on the growth plane (the normal direction of which is parallel to the growth direction) and the cross-section (the transverse direction of which is parallel to the growth direction) of the electrodeposits. Substantial grain growth and distinct texture evolution during growth-plane rolling and cross-section rolling were detected in the electrodeposited nanocrystalline alloy, and the corresponding mechanisms are discussed in this paper. (C) 2012 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
引用
收藏
页码：483 / 486
页数：4
相关论文
共 50 条
  • [41] Texture evolution of AZ31 magnesium alloy during extrusion and rolling
    Li, Xiu-Lian
    Wang, Mao-Yin
    Xin, Ren-Long
    Huang, Guang-Jie
    Liu, Qing
    Cailiao Rechuli Xuebao/Transactions of Materials and Heat Treatment, 2010, 31 (05): : 61 - 64
  • [42] Evolution of Goss texture in an Al–Cu–Mg alloy during cold rolling
    Qi Zhao
    Zhiyi Liu
    Yangcheng Hu
    Shasha Li
    Song Bai
    Archives of Civil and Mechanical Engineering, 20
  • [43] Texture Evolution in an Al-Cu-Mg Alloy During Hot Rolling
    Xia, Peng
    Liu, Zhiyi
    Wu, Wenting
    Zhao, Qi
    Lu, Luqing
    Bai, Song
    JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2018, 27 (07) : 3255 - 3267
  • [44] Preparation of nanocrystalline Ni-Fe strip via mechanical alloying-compaction-sintering-hot rolling route
    Vajpai, S. K.
    Dube, R. K.
    JOURNAL OF MATERIALS SCIENCE, 2009, 44 (01) : 129 - 135
  • [45] Texture Evolution During Cross Rolling and Annealing of High-Purity Nickel
    Bhattacharjee, Pinaki Prasad
    Joshi, M.
    Chaudhary, V. P.
    Gatti, J. R.
    Zaid, M.
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2013, 44A (06): : 2707 - 2716
  • [46] Texture Evolution During Cross Rolling and Annealing of High-Purity Nickel
    Pinaki Prasad Bhattacharjee
    M. Joshi
    V. P. Chaudhary
    J. R. Gatti
    M. Zaid
    Metallurgical and Materials Transactions A, 2013, 44 : 2707 - 2716
  • [47] The evolution of texture and microstructure uniformity in tantalum sheets during asymmetric cross rolling
    Zhu, Jialin
    Liu, Shifeng
    Long, Doudou
    Zhou, Shiyuan
    Zhu, Yulong
    Orlov, Dmytro
    MATERIALS CHARACTERIZATION, 2020, 168
  • [48] The onset and evolution of fatigue-induced abnormal grain growth in nanocrystalline Ni-Fe
    Furnish, T. A.
    Mehta, A.
    Van Campen, D.
    Bufford, D. C.
    Hattar, K.
    Boyce, B. L.
    JOURNAL OF MATERIALS SCIENCE, 2017, 52 (01) : 46 - 59
  • [49] Amorphous Intergranular Film Effect on the Texture and Structural Evolution During Cold-Rolling of Nanocrystalline Ni-Zr Alloys
    Reddy, K. Vijay
    Rupert, Timothy J.
    Pal, Snehanshu
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2022, 53 (03): : 1025 - 1034
  • [50] An analytical model for the prediction of cross-section profile and mean roll radius in alloy bar rolling
    Dong, Yonggang
    Zhang, Wenzhi
    Song, Jianfeng
    JOURNAL OF UNIVERSITY OF SCIENCE AND TECHNOLOGY BEIJING, 2008, 15 (03): : 344 - 351
12345