Influence zone around a closed-ended pile during vibratory driving

被引:42
|
作者
Ekanayake, S. D. [1 ]
Liyanapathirana, D. S. [1 ]
Leo, C. J. [1 ]
机构
[1] Univ Western Sydney, Sch Comp Engn & Math, Penrith, NSW 2751, Australia
基金
澳大利亚研究理事会;
关键词
Vibratory pile driving; Peak particle velocity; Finite element method; Wave transmitting; Boundaries; Adaptive meshing; FREE-FIELD VIBRATIONS; GROUND VIBRATIONS; PROPAGATION; FORMULATION; ATTENUATION;
D O I
10.1016/j.soildyn.2013.06.005
中图分类号
P5 [地质学];
学科分类号
0709 ; 081803 ;
摘要
This paper presents a numerical study based on vibratory driving of closed-ended piles. A set of axisymmetric finite element models were used to replicate the wave propagation during vibratory pile driving and to investigate the effect of wave propagation on the surrounding ground. The numerical modelling technique adopted for the analysis takes into account the large soil deformations around the pile during driving and is based on the Arbitrary Lagrangian Eulerian technique. It has the ability to drive a pile few pile diameters below the initial position without mesh distortions and the numerical model was verified using field data available in the literature. Soil was modelled as an elastic-perfectly plastic material. A parametric study was performed to determine the influence of change in pile driving force on the far field using different operating frequencies and amplitudes of the driving force, and rigidity index and material damping of the surrounding soil. The parameters for the driving force were extracted from the published specifications of commercially available vibratory piling rigs. Finite element results were compared with ground vibration measurements of peak particle velocities during vibratory sheetpile driving found in the literature. These results show that the material damping is an important parameter contributing to wave attenuation around the driven pile in addition to the geometric damping. The impact on the far field is discussed comparing the peak particle velocity distributions with the specifications given by the American Association of State Highways and Transportation Officials (AASHTO), Swiss Standard SN640312 and Eurocode 3 for acceptable vibrations to avoid damages to existing nearby structures. Finally attenuation relationships, and upper and lower bounds for the peak particle velocity distributions around a driven closed-ended pile are presented to determine the influence zones for different types of nearby structures. (C) 2013 Elsevier Ltd. All rights reserved.
引用
收藏
页码:26 / 36
页数:11
相关论文
共 47 条
  • [31] Influence of relative acceleration in saturated sand: Analytical approach and simulation of vibratory pile driving tests
    Staubach, P.
    Machacek, J.
    COMPUTERS AND GEOTECHNICS, 2019, 112 : 173 - 184
  • [32] Closure to "Static Capacity of Closed-Ended Pipe Pile Driven in Gravelly Sand" by Eshan Ganju, Fei Han, Monica Prezzi, and Rodrigo Salgado
    Ganju, Eshan
    Han, Fei
    Prezzi, Monica
    Salgado, Rodrigo
    JOURNAL OF GEOTECHNICAL AND GEOENVIRONMENTAL ENGINEERING, 2021, 147 (08)
  • [33] Centrifuge tests investigating the influence of pile cross-section on pile driving resistance of open-ended piles
    Henke, Sascha
    Bienen, Britta
    INTERNATIONAL JOURNAL OF PHYSICAL MODELLING IN GEOTECHNICS, 2013, 13 (02) : 50 - 62
  • [34] Numerical model to predict the propagation of particle velocity values during vibratory pile-driving
    Rocher-Lacoste, F.
    Sernblat, J. E.
    NUMERICAL MODELS IN GEOMECHANICS: NUMOG X, 2007, : 467 - 473
  • [35] Numerical investigation of inside peak particle velocities for predicting the vibration influence radius of vibratory pile driving
    Wei, Jiabin
    Wang, Weidong
    Wu, Jiangbin
    SOIL DYNAMICS AND EARTHQUAKE ENGINEERING, 2022, 153
  • [36] In situ investigation on pore-water pressure response during vibratory pile driving with high frequency
    Zhan, Jingyuan
    Chen, Jinjian
    Wang, Weidong
    Li, Mingguang
    ACTA GEOTECHNICA, 2024, 19 (05) : 2649 - 2668
  • [37] Acoustics During the Vibratory Pile Driving of Sheet Piles: Measurement Conditions and Key Parameters of the Noise Generation
    Hanus, V.
    Zuerbes, A.
    Maas, S.
    Waldmann, D.
    ACTA ACUSTICA UNITED WITH ACUSTICA, 2010, 96 (06) : 1104 - 1114
  • [38] Numerical evaluation of the soil behavior during pipe-pile installation using impact and vibratory driving in sand
    Daryaei, R.
    Bakroon, M.
    Aubram, D.
    Rackwitz, F.
    SOIL DYNAMICS AND EARTHQUAKE ENGINEERING, 2020, 134
  • [39] Analysis of Soil Response during High-Frequency Vibratory Steel Pipe Pile Driving in Soft Soil
    Chen, Fengjun
    Li, Xiaomi
    Zhao, Huiling
    Hu, Pei
    ADVANCES IN CIVIL ENGINEERING, 2024, 2024
  • [40] Numerical investigation of soil dynamic response during high-frequency vibratory pile driving in saturated soil
    Zhan, Jingyuan
    Li, Mingguang
    Chen, Jinjian
    Wang, Weidong
    SOIL DYNAMICS AND EARTHQUAKE ENGINEERING, 2023, 173