EMISSIONS AND PERFORMANCE ON A JATROPHA OIL METHYL ESTER FUELED DIESEL ENGINE WITH RETARDED INJECTION TIMING

被引:0
|
作者
Suryawanshi, J. G. [1 ]
机构
[1] Visvesvaraya Natl Inst Technol, Dept Mech Engn, Nagpur 440011, Maharashtra, India
关键词
Biodiesel; jatropha oil methyl ester; CI engine; emissions;
D O I
暂无
中图分类号
O414.1 [热力学];
学科分类号
摘要
Injection timing variations have a strong effect on NOx emissions for direct injection diesel engines. Retarded injection is commonly used to control NOx emissions. Biodiesel is a non-toxic, biodegradable and renewable fuel with the potential to reduce engine exhaust emissions. The methyl ester of jatropha oil, known as biodiesel, is receiving increasing attention as an alternative fuel for diesel engines. In the present investigation neat jatropha oil methyl ester (JME) as well as the blends of varying proportions of jatropha oil methyl ester (JME) and diesel were used to run a CI engine with standard injection timing and retarded injection timing. Significant improvements in engine performance and emission characteristics were observed for JME fuel. The addition of JME to diesel fuel has significantly reduced HC, CO, and smoke emissions but it increases the NOX emission slightly with standard injection timing. The NOX emission was decreased with retarded injection timing with negligible effect on fuel consumption rate. Similar trend in brake thermal efficiency and exhaust gas temperature was observed with retarded injection timing while maximum cylinder gas pressure and ignition delay was decreased.
引用
收藏
页数:8
相关论文
共 50 条
  • [31] Performance and emission characteristics of a diesel engine with varying injection pressure and fueled with hydrogen and cottonseed oil methyl ester blends
    Khan, Naseeb
    BaluNaik, B.
    Yousufuddin, Syed
    MATERIALS TODAY-PROCEEDINGS, 2018, 5 (02) : 3369 - 3377
  • [32] COMBUSTION CHARACTERISTICS OF DIESEL ENGINE OPERATING ON JATROPHA OIL METHYL ESTER
    Dhananjaya, Doddayaraganalu Amasegoda
    Sudhir, Chitrapady Visweswara
    Mohanan, Padmanbha
    THERMAL SCIENCE, 2010, 14 (04): : 965 - 977
  • [33] Experimental investigations on a jatropha oil methyl ester fuelled diesel engine
    Suryawanshi, J. G.
    Deshpande, N. V.
    Proceedings of the 2005 Spring Technical Conference of the ASME Internal Combustion Engine Division, 2005, : 253 - 260
  • [34] Jatropha oil methyl ester as diesel engine fuel - an experimental investigation
    Jaichandar, S.
    Annamalai, K.
    INTERNATIONAL JOURNAL OF AUTOMOTIVE AND MECHANICAL ENGINEERING, 2016, 13 (01) : 3248 - 3261
  • [35] INFLUENCE OF INJECTION TIMING AND COMPRESSION RATIO ON PERFORMANCE, EMISSION AND COMBUSTION CHARACTERISTICS OF JATROPHA METHYL ESTER OPERATED DI DIESEL ENGINE
    Senthil, R.
    Silambarasan, R.
    IRANIAN JOURNAL OF SCIENCE AND TECHNOLOGY-TRANSACTIONS OF MECHANICAL ENGINEERING, 2015, 39 (M1) : 61 - 76
  • [36] Effect of double injection on combustion, performance and emissions of Jatropha water emulsion fueled direct-injection diesel engine
    Kim-Bao Nguyen
    Dan, Tomohisa
    Asano, Ichiro
    ENERGY, 2015, 80 : 746 - 755
  • [37] Effect of compression ratio and injection timing on the performance characteristics of a diesel engine running on palm oil methyl ester
    Debnath, Biplab K.
    Saha, Ujjwal K.
    Sahoo, Niranjan
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY, 2013, 227 (03) : 368 - 382
  • [38] Performance and emission evaluation of a diesel engine fueled with methyl ester of neem oil and filtered neem oil
    Ragit, S. S.
    Mohapatra, S. K.
    Kundu, K.
    JOURNAL OF SCIENTIFIC & INDUSTRIAL RESEARCH, 2010, 69 (01): : 62 - 66
  • [39] Variation of performance and emission characteristics of a diesel engine fueled with diesel, rapeseed oil and hazelnut oil methyl ester blends
    Celikten, Ismet
    Mutlu, Emre
    Solmaz, Hamit
    RENEWABLE ENERGY, 2012, 48 : 122 - 126
  • [40] Analysis of the Emissions and Performance of a Diesel Engine Using Pumpkin Seed Oil Methyl Ester with Different Injection Pressures
    Kuppusamy, Surendrababu
    Muthuswamy, Prabhahar
    Kumarasamy, Muthurajan
    Subramanian, Sendilvelan
    FDMP-FLUID DYNAMICS & MATERIALS PROCESSING, 2023, 19 (04): : 1003 - 1014