The effects of particle shape, orientation, and Reynolds number on particle-wall collisions

Crystallisation is an important unit operation used in the production of Active Pharmaceutical Ingredients (APIs). Crystallisation is typically carried out using seed crystals in a process called secondary nucleation that allows for greater control of crystal quality attributes. The mechanism of secondary nucleation is still not well understood. Particle attrition is one proposed mechanism. This work examines the conditions under which particle-wall collisions occur. This is done through the simulation of free-moving particles in an impinging jet flow using an immersed-boundary lattice Boltzmann method (IB-LBM) CFD solver. Particle Reynolds numbers from 100 to 400 are examined. Particle shapes with aspect ratios from 1:1 to 8:1 are used to represent the crystal habits of APIs.Particles that start in their low-drag or high-drag orientation maintain this orientation on approach to the target surface. All other intermediate initial orientations examined cause particles to rotate toward and overshoot their high-drag form before adopting their high-drag form in proximity to the target surface. Particles in their low-drag form remain in their initial orientation due to the symmetry of the computational domain. In this orientation, a collision is most likely to occur, and the minimum critical Reynolds number at which a particle wall collision will occur can be determined. This value is shown to increase with increasing particle frontal length. Pointed or rounded leading edges are shown to improve a particle's ability to pierce the boundary layer adjacent to the target surface and reduce this value. In cases where a Reynolds number of 400 is insufficient to cause a particle-wall collision, the particles' minimum distances from the target surface are reported. Using the minimum critical Reynolds number values obtained, the approach velocities required for particles to collide with a wall are shown to be larger than the impeller tip speeds typically used during crystallisation operations. This work provides for the first time the conditions under which particle-wall collisions occur for varying shape and orientation, their behaviour on approach, and the associated impact velocities.