Atomistic analysis of temperature-dependent dislocation dynamics in Ni3Al-based intermetallic alloys

被引:5
|
作者
Wakeda, M. [1 ]
Osada, T. [1 ]
Ohmura, T. [1 ,2 ]
机构
[1] Natl Inst Mat Sci, Res Ctr Struct Mat, 1-2-1 Sengen, Tsukuba 3050047, Japan
[2] Kyushu Univ, Grad Sch Engn, 744 Motooka,Nishi Ku, Fukuoka 8190395, Japan
来源
关键词
High-temperature alloys; Intermetallics; Dislocations and disclinations; Phonons; Point defects; Molecular dynamics simulations; SCREW DISLOCATIONS; FRICTIONAL FORCE; MOBILITY; ALUMINUM; NI;
D O I
10.1016/j.mtcomm.2023.106987
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
In this study, we investigate the dynamics of superlattice edge dislocations composed of partial dislocations, complex stacking faults, and antiphase boundaries in binary and ternary Ni-based alloys (& gamma;' phase) with the L12 structure. In the case of Ni3Al, the dislocation velocity decreases with increasing temperature at low applied shear stress, mainly owing to the phonon drag effect. Meanwhile, in the case of ternary alloys constructed by exchanging Ni atoms with Co atoms in Ni3Al, the effects of temperature on dislocation motion are more complex. At low applied shear stress, the dislocation motion is disturbed by solute Co (i.e., solid-solution strengthening). In this case, the temperature promotes dislocation motion because the potential energy barrier dominates the thermally activated dislocation dynamics. In contrast, when the applied shear stress increases, the temperature suppresses dislocation motion owing to the phonon drag effect. The drag effect also increases with increasing Co concentration. The origin of the energy barrier due to solute atoms at low applied shear stress can be explained by the interaction between the partial dislocation and solute Co. Meanwhile, the origin of the drag effect on the superlattice dislocation dynamics is discussed on the basis of atomic vibrational motions and wavy dislocation behaviors. In this study, we propose and construct a map showing the dominant effects on complex superlattice dislocation dynamics. The map has energy-barrier-dominated, phonon-drag-dominated, and sound velocitydominated regions, suggesting that the dominant factor changes depending on the applied shear stress, temperature, and strength of the solute-dislocation interaction.
引用
收藏
页数:10
相关论文
共 50 条
  • [31] Effect of yttrium on oxidation behavior of Ni3Al-based single crystal alloys
    Yanfang Zhang
    Shusuo Li
    Yafang Han
    Rare Metals, 2011, 30 : 538 - 543
  • [32] INFLUENCE OF HEAT TREATMENT ON THE STRUCTURE AND MECHANICAL PROPERTIES OF Ni3Al-BASED ALLOYS
    Jozwik, P.
    Bojar, Z.
    ARCHIVES OF METALLURGY AND MATERIALS, 2010, 55 (01) : 271 - 279
  • [33] Nanocrystalline Ni3Al-based alloys produced by mechanical alloying of Ni-Al-Co powders and consolidation
    Antolak-Dudka, Anna
    Krasnowski, Marek
    Kulik, Tadeusz
    PHYSICA STATUS SOLIDI C - CURRENT TOPICS IN SOLID STATE PHYSICS, VOL 7 NO 5, 2010, 7 (05): : 1384 - 1387
  • [34] Short-Term High Temperature Oxidation Behavior of Pt-Modified Ni3Al-Based Alloys
    Zhang Zhixi
    Cao Yiran
    Cao Guanghui
    RARE METAL MATERIALS AND ENGINEERING, 2021, 50 (04) : 1270 - 1282
  • [35] THE EFFECT OF PREPARATION METHODS ON A MICROSTRUCTURE OF THE Ni3Al-BASED ALLOYS ALLOYED WITH MOLYBDENUM
    Pohludka, Martin
    Malcharczikova, Jitka
    Petlak, Daniel
    METAL 2015: 24TH INTERNATIONAL CONFERENCE ON METALLURGY AND MATERIALS, 2015, : 1619 - 1624
  • [36] Effect of yttrium on oxidation behavior of Ni3Al-based single crystal alloys
    Zhang Yanfang
    Li Shusuo
    Han Yafang
    RARE METALS, 2011, 30 : 538 - 543
  • [37] THERMODYNAMIC PROPERTIES OF NANOCRYSTALLINE NI3AL-BASED ALLOYS PREPARED BY MECHANICAL ATTRITION
    SURINACH, S
    MALAGELADA, J
    BARO, MD
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1993, 168 (02): : 161 - 164
  • [38] Processing and operating experience of Ni3Al-based intermetallic alloy IC-221M
    Sikka, VK
    Santella, ML
    Orth, JE
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1997, 240 : 564 - 569
  • [39] Influences of solution cooling rate on microstructural evolution of a multiphase Ni3Al-based intermetallic alloy
    Wu, Jing
    Li, Chong
    Liu, Yongchang
    Xia, Xingchuan
    Wu, Yuting
    Ma, Zongqing
    Wang, Haipeng
    INTERMETALLICS, 2019, 109 : 48 - 59
  • [40] Performances of Ni3Al-based intermetallic IC10 in creep-feed grinding
    Zhu, Xiaoxiang
    Wang, Wenhu
    Jiang, Ruisong
    Liu, Xiaofen
    Lin, Kunyang
    INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2020, 108 (03): : 809 - 820