Transient Simulation Analysis of Needle Roller Bearing in Oil Jet Lubrication and Planetary Gearbox Lubrication Conditions Based on Computational Fluid Dynamics

The transient lubrication conditions of rolling bearings are different in gearboxes and bearing testers. It has been observed that samples of qualified rolling bearings tested in rolling bearing testers often fail and do not meet lifespan requirements when employed in other lubrication conditions. This may be caused by different factors affecting the bearing in testing and applying lubrication. Needle roller bearings were selected for this study to investigate the causes of this phenomenon in terms of lubrication. Based on the computational fluid dynamics (CFD) method, fluid domain models for the same type of rolling bearings with different lubrication conditions were established. The transient flow fields of rolling bearings with oil jet lubrication in a tester and splash lubrication in a planetary gearbox were simulated. The air-oil transient distribution of rolling bearings in two kinds of lubrication was analyzed. The results indicate that the rotational speed significantly affected the oil jet lubrication of the needle roller bearing. The average oil volume fraction rose by 0.2 with the increase in the bearing speed from 1200 r/min to 6000 r/min and by 0.06 with the increase in the oil jet velocity from 8 m/s to 16 m/s. The splash lubrication of the bearings in the planetary gearbox was directly related to the immersion depth of the rolling bearings in the initial position. Meanwhile, the splash lubrication of the bearings was also affected by other factors, including the initial layout of the planetary gears. The increase in speed from 1200 r/min to 6000 r/min made the average oil volume fraction of splash lubrication decrease by 4.4%. The average oil volume fraction of the bearings with splash lubrication was better than that with oil jet lubrication by an average of 41.9% when the bearing speed was in the low-speed stage, ranging from 1200 r/min to 3600 r/min. On the contrary, the bearings with oil jet lubrication were better than those with splash lubrication by an average of 31.8% when the bearing speed was in the high-speed stage, ranging from 4800 r/min to 6000 r/min.