Spreading resistance and conductance anisotropy in multilayer MoS2

The increasing interest in realizing the full potential of two-dimensional (2D) layered materials for developing electronic components strongly relies on quantitative understanding of their anisotropic electronic properties. Herein, we use conductive atomic force microscopy to study the anisotropic electrical conductance of multilayer MoS(2 )by measuring the spreading resistance of circular structures of different radii ranging from 150 to 400 nm. The observed inverse scaling of the spreading resistance with contact radius, with an effective resistivity of rho eff = 2.89 Omega cm, is compatible with a diffusive transport model. A successive etch of the MoS2 nanofilms was used to directly measure the out-of-plane resistivity, i.e., 29.43 +/- 7.78 Omega cm. Based on the scaling theory for conduction in anisotropic materials, the model yields an in-plane resistivity of 0.28 +/- 0.07 Omega cm and an anisotropy of similar to 100 for the ratio between the in-plane and out-of-plane resistivities. The obtained anisotropy indicates that the probed surface area can extend up to 400 times the metal contact area, whereas the penetration depth is limited to roughly 20% of the contact radius. Hence, for contact radius less than 3 nm, the conduction will be limited to the surface. Our investigation offers important insight into the anisotropic transport behavior of MoS2, a pivotal factor enabling the design optimization of miniaturized devices based on 2D materials. (c) 2024 Author(s). All article content, except where otherwise noted, is licensed under a Creative Commons Attribution (CC BY) license (https://creativecommons.org/licenses/by/4.0/)