Driving Cycle Construction and Gear-shifting Analysis of AMT Semi-trailer Tractor

被引：0

作者：

Li, Bin ^{[1
]}

Liu, Hong-Li ^{[1
]}

Song, Rui ^{[1
]}

Ruan, Jia-Geng ^{[2
]}

机构：

[1] School of Automobile, Chang'an University, Shaanxi, Xi'an,710018, China

[2] College of Mechanical and Energy Engineering, Beijing University of Technology, Beijing,100020, China

来源：

Zhongguo Gonglu Xuebao/China Journal of Highway and Transport | 2024年 / 37卷 / 09期

关键词：

In rccent years; the market sharc of AMT heavy semi-trailer tractor (AMT tractor hereinafter) in China has expanded rapidly. However; research pertaining to this vehicle type has not progressed accordingly with this trend; and the vehicle Performance can be further improved. Thus; typical driving cycles for AMT tractors in China should be established; shifting scenarios analyzed; and stylistic cycles construeted to facilitate the optimization of AMT shifting strategies. This will improve the power; economic; and environmental Performances of thc vchiclc and allow thc advantages of AMT tractors to bc leveraged more effectively. Using measured data of the vehicle; the Douglas-Peucker algorithm was applied to disperse the speed and power indicators such that the difference and trend data of the two indicators can be obtained. Subsequently; four typical shifting scenarios; i; e; acceleration; deceleration; starting; and parking; were efficiently constructed; and the shifting speeds; power-consumption fluctuation; number of shifts; and shifting load were counted and analyzed under different scenarios. Next; a non-freeway driving cycle was constructed using the improved short-trip mcthod combined with the t-SNE and K-means algorithms; and a freeway driving cycle was constructed using the Markov chain method to compensate for the intrinsic defects of the short-trip method. Finally; based on thc non-freeway driving cycle; an objective scoring method was used to distinguish between conservative and aggressive difference data; after which they were superimposed on thc non-freeway cycle skeleton to construet style cycles more flcxibly. The results are as follows: The shifting velocity of the AMT tractor is particularly evident in two intervals; 0-20; and; 55-70; km; •; h~; and the four typical shifting scenarios are different from each other. This implics that the dynamics and economic tendency of the shifting strategy should be dynamically adjusted depending on the scenario. The average relative error (MRE) of the indicators for the freeway and non-freeway driving cycles are 4. 834% and 3. 431%; respectively (while the latter reduced by 27. 49% compared with thc conventional method); and the MREs of thc simulated fuel consumption are 6. 68% and 3. 97%; respectively; thus indicating that the two cycles are superior to the Standard cycles of CHTC-TT and C-WTVC. The MREs of both the aggressive and conservative driving cycles are approximately 5. 6%; which indicates that they can be used to evaluate the Performance of the shifting strategy under different driving intensities. The MREs based on the conventional method and style cycles exceed 3. 431%; which indicates that the driving bchavior data must be separated during the construetion of the driving cycle to mitigate the negative impact. © 2024 Chang'an University. All rights reserved;

D O I：

10.19721/j.cnki.1001-7372.2024.09.025

中图分类号：

学科分类号：

摘要：

引用

页码：312 / 326

共 50 条

[1] Ddistribution of driving moments and pulls on tractor and semi-trailer wheels
Semetko, J
Janosko, I
Pernis, P
ACTUAL TASKS ON AGRICULTURAL ENGINEERING, PROCEEDINGS, 2002, 30 : 129 - 135
[2] Analysis of bifurcation and stability for a tractor semi-trailer in planar motion
Ding, Nenggen
Shi, Xiaobo
Zhang, Yipeng
Chen, Wen
VEHICLE SYSTEM DYNAMICS, 2014, 52 (12) : 1729 - 1751
[3] Jackknife control on tractor semi-trailer during high speed curve driving
Zhou, Shuwen
Zhang, Siqi
Sensors and Transducers, 2012, 16 (SPEC. 1): : 277 - 284
[4] Ride Comfort Analysis of Unsuspended Cabin Tractor Semi-Trailer
Velmurugan, P.
Sankaranarayanasamy, K.
Kumaraswamidhas, L.A.
Pazhanivel, K.
International Journal of Vehicle Structures and Systems, 2014, 6 (04) : 104 - 109
[5] Study on tractor semi-trailer roll stability control
Zhou, Shuwen, 1600, Bentham Science Publishers B.V., P.O. Box 294, Bussum, 1400 AG, Netherlands (08):
[6] Research on Algorithm of Stability Control for Tractor Semi-trailer
Mai, Li
Xie, Pu
Zong, Changfu
2009 IEEE INTERNATIONAL CONFERENCE ON MECHATRONICS AND AUTOMATION, VOLS 1-7, CONFERENCE PROCEEDINGS, 2009, : 4224 - +
[7] Research on Driving Cycles of Heavy Semi-trailer Tractor and Optimization of Its Powertrain System
You G.
Lu J.
Su J.
Luan M.
Huang S.
Qiche Gongcheng/Automotive Engineering, 2022, 44 (11): : 1735 - 1745
[8] A MATHEMATICAL MODEL OF OPERATION OF A SEMI-TRAILER TRACTOR POWERTRAIN
Dizo, Jan
Blatnicky, Miroslav
Melnik, Rafal
Kravchenko, Oleksandr
KOMUNIKACIE - VEDECKE LISTY ZILINSKEJ UNIVERZITY V ZILINE, 2022, 24 (03):
[9] Prediction and detection of jackknifing problems for tractor semi-trailer
Bouteldja, M.
Koita, A.
Dolcemascolo, V.
Cadiou, J. C.
2006 IEEE VEHICLE POWER AND PROPULSION CONFERENCE, 2006, : 335 - +
[10] Evaluation of Dynamic Load Reduction for a Tractor Semi-Trailer Using the Air Suspension System at all Axles of the Semi-Trailer
Ha, Dang Viet
Tan, Vu Van
Niem, Vu Thanh
Sename, Olivier
ACTUATORS, 2022, 11 (01)

← 1 2 3 4 5 →