The effect of porosity on distortion of liquid phase sintered tungsten heavy alloys

被引：0
|
作者：
P/M Laboratory, 118 Research West, Pennsylvania State University, University Park, PA 16802-6809, United States [1 ]
机构：
来源：
Int J Refract Met Hard Mater | / 5卷 / 369-379期
关键词：
D O I：
暂无
中图分类号：
学科分类号：
摘要：
Porosity effects on distortion during liquid phase sintering were investigated experimentally. W-Ni-Fe alloys with compositions ranging from 78 to 93 wt% tungsten were liquid phase sintered at 1500°C for 30 min. Surprisingly, the results show that porosity has no appreciable effect on distortion. After sintering, similar distortion profiles were obtained for compacts with both high and low green porosities. On the other hand, distortion reduced with increasing solid:liquid ratio. No distortion occurred for samples with 93 wt% tungsten. Quenching experiments showed the onset of slumping was delayed until densification neared completion. In high liquid content samples, this means slumping occurred within a few minutes after melt formation, corresponding to liquid exudation. The results are in agreement with model predictions by German. The sintered microstructures were quantitatively measured for solid volume fraction and contiguity. No apparent effects of green porosity on micro structural evolution were observed. © 1999 Published by Elsevier Science Ltd. All rights reserved.
引用
收藏
相关论文
共 50 条
  • [31] EFFECT OF STRAIN RATE ON THE FLOW-STRESS OF 3 LIQUID-PHASE SINTERED TUNGSTEN ALLOYS
    WOODWARD, RL
    BALDWIN, NJ
    BURCH, I
    BAXTER, BJ
    METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1985, 16 (11): : 2031 - 2037
  • [32] Effect of nanocrystalline tungsten powders on the microstructure and properties of liquid-phase sintered 93 W alloys
    Yu, Yang
    Wang, Er-De
    Hu, Lian-Xi
    Cailiao Kexue yu Gongyi/Material Science and Technology, 2006, 14 (04): : 385 - 388
  • [33] SEGREGATION TO INTERPHASE BOUNDARIES IN LIQUID-PHASE SINTERED TUNGSTEN ALLOYS.
    Lea, C.
    Muddle, B.C.
    Edmonds, D.V.
    Metallurgical transactions. A, Physical metallurgy and materials science, 1983, 14 A (03): : 667 - 677
  • [34] CONTIGUITY VARIATION IN TUNGSTEN SPHEROIDS OF SINTERED HEAVY ALLOYS
    SRIKANTH, V
    UPADHYAYA, GS
    METALLOGRAPHY, 1986, 19 (04): : 437 - 445
  • [35] THE EFFECT OF VOLUME FRACTION ON GRAIN GROWTH DURING LIQUID PHASE SINTERING OF TUNGSTEN HEAVY ALLOYS
    Johnson, John L.
    Campbell, Louis G.
    Park, Seong Jin
    German, Randall M.
    ADVANCES IN SINTERING SCIENCE AND TECHNOLOGY, 2010, 209 : 71 - +
  • [36] Sintered alloys. Part I. Copper-nickel-tungsten alloys sintered with a liquid phase present.
    Price, GHS
    Smithells, CJ
    Williams, SV
    JOURNAL OF THE INSTITUTE OF METALS, 1938, 62 : 239 - 254
  • [37] Finite element simulation of liquid phase sintering with tungsten heavy alloys
    Park, Seong Jin
    Chung, Suk Hwan
    Johnson, John L.
    German, Randall M.
    MATERIALS TRANSACTIONS, 2006, 47 (11) : 2745 - 2752
  • [38] Improving the Fracture Toughness and Ductility of Liquid-Phase Sintered WNiFe Tungsten Heavy Alloys by High-Temperature Annealing
    Alam, Md Ershadul
    Odette, G. Robert
    MATERIALS, 2023, 16 (03)
  • [39] Effect of Transition Metals Oxides on the Physical and Mechanical Properties of Sintered Tungsten Heavy Alloys
    Elsayed, Ayman H.
    Sayed, Mohamed A.
    Dawood, Osama M.
    Daoush, Walid M.
    CRYSTALS, 2020, 10 (09): : 1 - 14
  • [40] Tensile and impact properties of microwave sintered tungsten heavy alloys
    Prabhu, G.
    Kumar, N. Arvind
    Sankaranarayana, M.
    Nandy, T. K.
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2014, 607 : 63 - 70
12345