Anisotropy of Deep Drawing Sheet Metal.

被引：0
|
作者：
Bischoff, Wilhelm
机构：
来源：
| 1978年 / 25卷 / 12期
关键词：
METAL DRAWING - Deep - SHEET AND STRIP METAL - STEEL SHEET;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The article deals with anisotropy which can be observed in deep drawing unalloyed steel sheet. The effect of the metal forming process on the orientation of the structural components is shown to lead to orientation-dependent strength and deformation characteristics. The possibilities of determining these anistropy properties are shown and the results of these test methods are described.
引用
收藏
页码：601 / 606
相关论文
共 50 条
  • [21] SELECTING DIE MATERIALS FOR SHEET METAL.
    Kortesoja, Victor A.
    Manufacturing Engineering and Management (Formerly Tool and Manufacturing Engineer), 1976, 76 (06): : 38 - 39
  • [22] Automatic Flame Cutting of Sheet Metal.
    Leiseder, Ludwig
    Baender Bleche Rohre, 1974, 15 (01): : 9 - 14
  • [23] Piercing and Hole Flanging of Sheet Metal.
    Ghosh, Swadhin K.
    Mamalis, Athanasios G.
    Baender Bleche Rohre, 1980, 21 (11): : 489 - 495
  • [24] Forming of Aluminum Alloy Sheet Metal.
    Blaich, Michael
    Baender Bleche Rohre, 1980, 21 (06): : 249 - 253
  • [25] Characteristics for the Deformability of Unalloyed Sheet Metal.
    Reitzle, Wolfgang
    Drecker, Hubert
    Fischer, Fritz
    Baender Bleche Rohre, 1981, 22 (03): : 50 - 53
  • [26] Analysis of deep drawing of sheet metal using the Marform process
    Ramezani, Maziar
    Ripin, Zaidi Mohd
    INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY, 2012, 59 (5-8): : 491 - 505
  • [27] Dry Deep Drawing of Aluminum and the Influence of Sheet Metal Roughness
    Felix Flegler
    Peter Groche
    Tim Abraham
    Günter Bräuer
    JOM, 2020, 72 : 2511 - 2516
  • [28] Dry Deep Drawing of Aluminum and the Influence of Sheet Metal Roughness
    Flegler, Felix
    Groche, Peter
    Abraham, Tim
    Braeuer, Guenter
    JOM, 2020, 72 (07) : 2511 - 2516
  • [29] Elastic deflections of the blank holder in deep drawing of sheet metal
    Shulkin, L
    Jansen, SW
    Ahmetoglu, MA
    Kinzel, GL
    Altan, T
    JOURNAL OF MATERIALS PROCESSING TECHNOLOGY, 1996, 59 (1-2) : 34 - 40
  • [30] Thinning and residual stresses of sheet metal in the deep drawing process
    El Sherbiny, M.
    Zein, H.
    Abd-Rabou, M.
    El Shazly, M.
    MATERIALS & DESIGN, 2014, 55 : 869 - 879
12345