PREDICTING CASE DEPTHS FOR GEARS.

被引：0
|
作者：
Sharma, V.K.
Walter, G.H.
Breen, D.H.
机构：
来源：
Product Engineering (New York) | 1979年 / 50卷 / 06期
关键词：
GEAR MANUFACTURE - Analysis - STEEL HEAT TREATMENT - Carburizing - STEEL TESTING - Hardness;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
When gears transmit torque, they are subjected to bending and contact loads which, when applied repeatedly, can cause the gears to fail by fatigue. This article outlines an analytical approach for predicting case depth requirements for carburized and hardened gears that can save as much as 30% of process time. Once the steel composition and quench rate are chosen, the best carburizing cycle is the one that develops a strength gradient such that fatigue strength will exceed applied stresses at all points on and below the surface with a reasonable level of safety.
引用
收藏
页码：49 / 52
相关论文
共 50 条
  • [41] Modifying the Profile of Ground Worm Gears.
    Kacalak, Wojciech
    Lewkowicz, Ryszard
    Werkstatt und Betrieb, 1984, 117 (02): : 85 - 88
  • [42] STRENGTH CALCULATION OF LARGE HELICAL GEARS.
    Kubo, Aizoh
    Hirasawa, Hiroshi
    Yamada, Tominori
    Bulletin of the JSME, 1979, 22 (166): : 605 - 612
  • [43] EPICYCLIC REVERSE-REDUCTION GEARS.
    Anon
    Shipbuilding & marine engineering international, 1982, 105 (1257): : 127 - 128
  • [44] EFFECT OF RESIDUAL STRESS ON THE BENDING FATIGUE STRENGTH OF CASE HARDENED GEARS.
    Nishioka, Kunio
    Nishio, Atsushi
    Hirakawa, Kenji
    Komatsu, Hideo
    1600,
  • [45] Planetary Pin-Type Gears.
    Wojnarowski, Jozef
    Kalinski, Wladyslaw
    1600, (31):
  • [46] Stepless Drives Coupled with Planetary Gears.
    Koziarski, Czeslaw
    Przeglad Mechaniczny, 1985, 44 (10): : 9 - 12
  • [47] Slab Hobbing of Hardened Cylindrical Gears.
    Spreemann, Uwe
    1600, (120):
  • [48] Method for Reducing Acoustic Activity of Gears.
    Bolotov, B.E.
    Klebanov, M.K.
    Panov, S.N.
    Rodionov, O.E.
    1978, (02): : 184 - 185
  • [49] Graphic demonstration of step wheel gears.
    Langner, R
    ZEITSCHRIFT DES VEREINES DEUTSCHER INGENIEURE, 1913, 57 : 1537 - 1543
  • [50] Construction Types of Gas Turbine Gears.
    Hiersig, Heinz M.
    MTZ Motortechnische Zeitschrift, 1977, 38 (11) : 503 - 508
12345