Roughness measurement at injection molded plastic parts with optical surfaces

被引：0
|
作者：
Bürger, Wolfgang [1 ]
Bliedtner, J. [1 ]
Roeder, J. [1 ]
Müller, W. [1 ]
机构：
[1] Inst. Fugetech./Werkstoffprung. GmbH, Otto-Schott-Str. 13, 07745 Jena
来源：
| 2003年 / VDI Verlag GMBH卷
关键词：
Atomic force microscopy - Injection molding - Optical systems - Plastic parts - Roughness measurement;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
In this chapter selected results of experimental investigations about determination of roughness measurement at injection molded plastic parts with flat optical surfaces are presented.
引用
收藏
相关论文
共 50 条
  • [21] INJECTION-MOLDED PLASTIC CONNECTOR FOR SPLICING OPTICAL CABLES
    CHERIN, AH
    RICH, PJ
    BELL SYSTEM TECHNICAL JOURNAL, 1976, 55 (08): : 1057 - 1067
  • [22] Warpage prediction of the injection-molded strip-like plastic parts
    Wang, Chaofang
    Huang, Ming
    Shen, Changyu
    Zhao, Zhenfeng
    CHINESE JOURNAL OF CHEMICAL ENGINEERING, 2016, 24 (05) : 665 - 670
  • [23] Warpage prediction of the injection-molded strip-like plastic parts
    Chaofang Wang
    Ming Huang
    Changyu Shen
    Zhenfeng Zhao
    Chinese Journal of Chemical Engineering, 2016, 24 (05) : 665 - 670
  • [24] Intelligent knowledge based engineering modules for producing plastic injection molded parts
    Dwivedi, SN
    Kumbakonam, A
    Yammada, J
    Tadikonda, V
    Chambers, TL
    CONCURRENT ENGINEERING: ADVANCED DESIGN, PRODUCTION AND MANAGEMENT SYSTEMS, 2003, : 1263 - 1268
  • [25] Influence of Material and Processing Parameters on the Surface Roughness of Injection-Molded Ceramic Parts
    Greiner, S.
    Kurth, K.
    Fix, C.
    Braun, T.
    Franke, J.
    Drummer, D.
    JOURNAL OF CERAMIC SCIENCE AND TECHNOLOGY, 2017, 8 (02): : 277 - 286
  • [26] Optimization possibilities for injection-molded parts - Use of measurement technology
    Optimierungsmöglichkeiten an spritzgussbauteilen – nutzung von messtechnik
    1600, VDI Verlag GMBH
  • [27] CHECKLIST FOR DESIGNING MOLDED PLASTIC PARTS
    HENRY, DW
    MACHINE DESIGN, 1978, 50 (18) : 114 - 118
  • [28] Development of runner reservoir and its effect on optical properties of small high-precision plastic injection molded parts
    Shotwell, Demitri
    Lin, Mong-Tung
    Liu, Jia-Hau
    Turng, Lih-Sheng
    PLASTICS RUBBER AND COMPOSITES, 2023, 52 (06) : 330 - 345
  • [29] Molded parts make plastic engine
    Bak, David J., 1600, (45):
  • [30] MEASUREMENT OF ROUGHNESS OF SUPERSMOOTH OPTICAL-SURFACES
    WYANT, JC
    ACTA POLYTECHNICA SCANDINAVICA-APPLIED PHYSICS SERIES, 1985, (150): : 241 - 244
12345