Optimization design of a powertrain mount-system based on the TPA and genetic algorithm

被引：0
|
作者：
Pan G. [1 ,2 ]
Fu B. [1 ]
Wang G. [1 ,2 ]
Chen Q. [2 ]
Zhu R. [1 ]
Li D. [1 ,2 ]
机构：
[1] School of Automotive and Transport Engineering, Jiangsu University, Zhenjiang
[2] Jiangxi Province Key Laboratory of Vehicle Noise and Vibration(Jiangling Motors Corporation, Ltd.), Nanchang
来源：
Zhendong yu Chongji/Journal of Vibration and Shock | 2021年 / 40卷 / 14期
关键词：
Dynamic stiffness method; Energy decoupling; Genetic algorithm; Stiffness optimization;
D O I：
10.13465/j.cnki.jvs.2021.14.036
中图分类号：
学科分类号：
摘要：
Aiming at the idle jitter problem of a passenger car with front engine front wheeldrive(FF) installation, an optimal design method of its powertrain mount system based on the transfer path analysis(TPA) and genetic algorithm was proposed. By the TPA technology, the inherent characteristics of the mount-system were correlated to the associated vibration response at target points of the vehicle. Comprehensively utilizing a six degrees of freedom model of the mount-system and considering the decoupling rate and the inherent frequency distribution, a mount-system optimization mathematical model was established. Then the NSGA-II genetic algorithm was used in the multi-objective optimization and the optimal stiffness parameters were obtained. The optimal results were used to remake the mount-system and to do the test. The experimental results show that the vibration isolation performance of the optimized mount-system is greatly improved, the vibration response is better than that of the original target car, the idling jitter problem of the passenger car is effectively solved, and the effectiveness of the proposed optimization method is verified. © 2021, Editorial Office of Journal of Vibration and Shock. All right reserved.
引用
收藏
页码：279 / 286
页数：7
相关论文
共 15 条
  • [11] (2014)
  • [12] (2016)
  • [13] OOI L E, ZAIDI M R., Optimization of an engine mounting system with consideration of frequency-dependent stiffness and loss factor, Journal of Vibration & Control, 22, 10, pp. 178-186, (2014)
  • [14] LU Chihua, LIU Yongchen, LIU Zhien, Et al., Optimization design for improving the vibration modes decoupling rate and vibration isolation performance of a powertrain mounting system based on the genetic algorithm, Journal of Vibration and Shock, 37, 14, pp. 248-253, (2018)
  • [15] CHAN J K, YEON J K, BONG H L, Et al., Determination of optimal position for both support bearing and unbalance mass of balance shaft, Mechanism & Machine Theory, 50, 50, pp. 150-158, (2012)
12