Contact Characteristic Prediction of Double-Locking Toolholder-Spindle System at High Speed

被引：0
|
作者：
Zhao Y. [1 ]
Xu J. [1 ]
Cai L. [1 ]
Liu Z. [1 ]
机构：
[1] College of Mechanical Engineering and Applied Electronics Technology, Beijing University of Technology, Beijing
来源：
| 2017年 / Nanjing University of Aeronautics an Astronautics卷 / 37期
关键词：
Contact stiffness; Double-locking toolholder-spindle; High-speed; Three-dimensional fractal theory;
D O I：
10.16450/j.cnki.issn.1004-6801.2017.04.006
中图分类号：
学科分类号：
摘要：
The finite element analysis is applied to obtain the contact pressure of the contact surfaces at different speed. Based on the three-dimensional fractal model and Hertz theory the contact stiffness of the double locking toolholder-spindle system is obtained, then the simulation model is built to obtain the contact characteristic of the system at high speed. Based on the theoretical model the influences of the different parameters on the taper-surface contact ratio and the contact stiffness are revealed. Finally, the upper limit of the speed and the reasonable ranges of the draw-bar force, disk-spring stiffness and pre-tightening force are defined. All the research results will be a good theoretical basis for the structural design and optimization of the double-locking toolholder-spindle system. © 2017, Editorial Department of JVMD. All right reserved.
引用
收藏
页码：673 / 680
页数：7
相关论文
共 16 条
  • [11] Wang S., Komvopoulos K., A fractal theory of the interracial temperature distribution in the slow sliding regime: part I-elastic contact and heat transfer analysis, Journal of Tribology, Transcations of ASME, 116, 4, pp. 812-823, (1994)
  • [12] Yan W., Komvopoulos K., Contact analysis of elastic-plastic fractal surfaces, Jounral of Applied Physics, 84, 7, pp. 3617-3624, (1998)
  • [13] Liou J.L., The theoretical study for microcontact model with variable topography parameters, (2006)
  • [14] Zhang X., Wang N., Lan G., Et al., Tangential damping and its dissipation factor models of joint interfaces based on fractal theory with simulations, Journal of Tribology, 136, 1, (2014)
  • [15] Zhang R., Cai B., Numerical method of the power spectral density, High Power Laser and Particle Beams, 12, pp. 661-664, (2000)
  • [16] Zhang S., Ai X., Finite element analysis of HSK spindle/toolholder interface, Mechanical Science and Technology, 23, 6, pp. 631-633, (2004)
12