Pull out tests to study anchorage / bond on concrete specimen with embedded helical end rebar (HER)

被引:0
|
作者
Saraswathi, Adla [1 ]
Rao, C.B.K. [1 ]
Seshu, D. Rama [1 ]
机构
[1] Department of Civil Engineering, National Institute of Technology, Warangal,506 004, India
来源
关键词
Anchorages; (foundations);
D O I
暂无
中图分类号
学科分类号
摘要
In order to develop full stress, rebar needs to be extended beyond a section for a length equal to development length in a reinforced concrete member. U-Hook or bent up bar is a solution to overcome the problem of development length, but congestion of reinforcement is an issue. Many a time, there will be shortfall, and mechanical anchorages or headed bars in place of hooks were used to overcome the congestion issue. An alternative method of anchorage with Helical End Rebar (HER) was investigated by conducting a pull-out test. HER may not fully address the issue of congestion. Parameters considered in the investigation are the diameter of the coil, pitch of coil and number of coils embedded in concrete. All these are combined as helix coefficient. It is found that the helix coefficient influences the anchorage of Helical End Rebar. © 2021, Structural Engineering Research Centre. All rights reserved.
引用
收藏
页码:265 / 273
相关论文
共 50 条
  • [31] Three-dimensional analytical model for the pull-out response of anchor-mortar-concrete anchorage system based on interfacial bond failure
    Wang, Yan-Jie
    Wu, Zhi-Min
    Zheng, Jian-Jun
    Zhou, Xiang-Ming
    ENGINEERING STRUCTURES, 2019, 180 : 234 - 248
  • [32] Bond behavior of flexible braided AFRP tendons in high-performance concrete based on pull-out and beam tests
    Xue, Weichen
    Li, Jia
    Wang, Yuan
    JOURNAL OF BUILDING ENGINEERING, 2023, 80
  • [33] Steel-concrete bond behaviour of concrete mixes with wood waste: pull-out and bending tests of full-scale beams and columns
    Dias, Sara
    Tadeu, Antonio
    Almeida, Joao
    Antonio, Julieta
    de Brito, Jorge
    CONSTRUCTION AND BUILDING MATERIALS, 2023, 383
  • [34] Fiber-matrix bond strength by pull-out tests on slag-based geopolymer with embedded glass and carbon fibers
    Alves, Lais
    Leklou, Nordine
    Casari, Pascal
    de Barros, Silvio
    JOURNAL OF ADHESION SCIENCE AND TECHNOLOGY, 2021, 35 (18) : 2035 - 2045
  • [35] Pull-out and bond-slip performance of steel fibers with various ends shapes embedded in polymer-modified concrete
    Esmaeili, Jamshid
    Andalibi, Keyvan
    Gencel, Osman
    Maleki, Farshid Khosravi
    Maleki, Vahid Arab
    CONSTRUCTION AND BUILDING MATERIALS, 2021, 271
  • [36] Bond-slip behavior of fiber-reinforced polymer/concrete interface in single shear pull-out and beam tests
    Mohammadi, Tayyebeh
    Wan, Baolin
    Harries, Kent A.
    JOURNAL OF REINFORCED PLASTICS AND COMPOSITES, 2016, 35 (05) : 375 - 386
  • [37] Pull-out bond strength and flexural load test of concrete beam with ethylene-vinyl acetate-modified cement slurry-coated rebar
    Jo, Youngkug
    Do, Jeongyun
    ADVANCES IN STRUCTURAL ENGINEERING, 2018, 21 (14) : 2130 - 2142
  • [38] On the Pull-Out Behavior of Hooked-End Shape Memory Alloys Fibers Embedded in Ultra-High Performance Concrete
    Baghal, Amir Ebrahim Akbari
    Maleki, Ahmad
    Vafaei, Ramin
    INTERNATIONAL JOURNAL OF ENGINEERING AND TECHNOLOGY INNOVATION, 2021, 11 (04) : 265 - 277
  • [39] Bond performance of NSM CFRP strips embedded in concrete using direct pull-out testing with cementitious adhesive made with graphene oxide
    Al-Saadi, Nihad Tareq Khshain
    Mohammed, Alyaa
    Al-Mahaidi, Riadh
    CONSTRUCTION AND BUILDING MATERIALS, 2018, 162 : 523 - 533
  • [40] Experimental study of bond behavior of geopolymer concrete under different curing condition using a pull-out test
    Bayrak, Baris
    Akarsu, Oguzhan
    Kilic, Mahmut
    Alcan, Haluk Gorkem
    Celebi, Oguzhan
    Kaplan, Gokhan
    Aydin, Abdulkadir Cuneyt
    CONSTRUCTION AND BUILDING MATERIALS, 2024, 439