Numerical and experimental investigation of the supercooled large droplets icing of rotating spinner

The icing of aero-engine rotating components is more complex than traditional aircraft icing. A threedimensional numerical method was developed based on the Eulerian method to study the supercooled large droplets icing of a rotating spinner. Typical dynamic behaviours of supercooled large droplets, such as deformation, breakup, rebound, and splashing, were considered. An icing thermodynamic model applicable to a rotating spinner was established by considering the effects of pressure gradient, air shear force, and centrifugal force on the flow of the water film. Meanwhile, an ice wind tunnel experiment on supercooled large droplets icing of a rotating spinner was carried out. The results showed that the maximum relative deviation of the simulated icing thickness at the cone tip is no more than 15% compared with the experimental result, and the icing thickness on the surface of the rotating spinner is basically consistent with the experimental result. Based on the three-dimensional numerical method developed in this study, the effects of the rotational speed, inflow velocity, and inflow temperature on the supercooled large droplets icing of a rotating spinner were investigated. As the rotational speed increases, the rebound and splashing of supercooled large droplets becomes more obvious, leading to an increase in the mass loss coefficient and a decrease in the collected mass of water droplets on the surface of the rotating spinner. Consequently, the icing thickness at the tail of the rotating spinner decreases with an increase in the rotational speed. Since the liquid water content in the environment is relatively low, water droplets freeze immediately after impacting the surface of the rotating spinner and rime ice is usually formed. When the inflow temperature is relatively high, overflow water exists and glaze ice is formed near the tip of the rotating spinner. The findings of this study can provide valuable support for the design and verification of anti-icing systems for aero-engine rotating spinner.