Frost accumulation in the non-hygroscopic rotary heat exchanger for heat recovery

被引:0
|
作者
Kanas, Paulina [1 ]
Jedlikowski, Andrzej [1 ]
Anisimov, Sergey [1 ]
机构
[1] Wroclaw Univ Sci & Technol, Fac Environm Engn, Dept Air Conditioning Heating Gas Engn & Air Prote, 4-6 Norwida st, PL-50373 Wroclaw, Poland
关键词
Thermal wheel; Heat transfer; Waste heat recovery; Frost formation; ENERGY WHEEL EFFECTIVENESS; FLAT-PLATE; TRANSIENT MEASUREMENTS; FREEZE PROTECTION; PART II; MODEL; OPTIMIZATION; VENTILATION; GROWTH; IMPACTS;
D O I
10.1016/j.ijheatmasstransfer.2024.125608
中图分类号
O414.1 [热力学];
学科分类号
摘要
In this paper, a process of frost accumulation inside the non-hygroscopic rotary heat exchanger depending on operating conditions is investigated. The study was based on the results of the numerical simulations conducted in the original computer program. The analysis considers both the threshold conditions of frost accumulation and the conditions of frost layer growth. For this purpose, three indicators related to frost accumulation were distinguished: a frost accumulation limit temperature, a surface of the matrix covered with the accumulated frost layer, a maximum thickness of the accumulated frost layer. The analyzes assessed the influence of operating parameters on these indicators, focusing on the return air relative humidity. It was revealed that the highest values of this parameter cause the greater thickness of the frost layer. However, the largest ' frost' accumulation area was created in the range of average return air relative humidity values - in the analyzed cases it was RH 2 i =38.5 %. The paper also includes a detailed analysis of the threshold temperature of frost accumulation. These limits of outdoor air temperature were determined for a wide range of operating parameters ' values: both airstream relative humidity and nominal temperature effectiveness. Additionally, eight probable configurations of active heat and mass transfer areas within rotary heat exchanger channels were revealed, which are related to the initiation of frost accumulation. Consequently, the locations of the initial ' frost' accumulation area were predicted. It was also found that the greatest impact on the frost accumulation threshold temperature has the return air relative humidity RH 2 i , although this influence is not unequivocal. The most unfavorable conditions regarding nominal temperature effectiveness in terms of frost accumulation are also unclear. In some cases, it was even demonstrated that an increase in the effectiveness can eliminate the ' frost' accumulation area.
引用
收藏
页数:30
相关论文
共 50 条
  • [21] PARALLEL FLOW THROUGH ROTARY HEAT EXCHANGER
    THEOCLIT.G
    ECKRICH, TL
    CHEMICAL ENGINEERING PROGRESS, 1966, 62 (07) : 74 - &
  • [22] Hydrodynamic Calculation of Rotary Regenerative Heat Exchanger
    Tsygankov, A. V.
    Dolgovskaia, O. V.
    Kuznetsov, Y. L.
    Shilin, A. S.
    OIL AND GAS ENGINEERING (OGE-2018), 2018, 2007
  • [23] PERFORMANCE OF REVOLVING HEAT PIPES AND APPLICATION TO A ROTARY HEAT-EXCHANGER
    NIEKAWA, J
    MATSUMOTO, K
    KOIZUMI, T
    HASEGAWA, K
    KANEKO, H
    MIZOGUCHI, Y
    JOURNAL OF HEAT RECOVERY SYSTEMS, 1981, 1 (04): : 331 - 338
  • [24] HEAT-TRANSFER ANALYSIS IN DRY ROTARY HEAT-EXCHANGER
    FRANKOVIC, B
    STROJARSTVO, 1993, 35 (3-4): : 111 - 120
  • [25] Application of an enameled heat exchanger to waste heat recovery
    Wang, CH
    Chiang, SC
    Yang, BC
    Shyu, RJ
    COMPACT HEAT EXCHANGERS AND ENHANCEMENT TECHNOLOGY FOR THE PROCESS INDUSTRIES, 1999, : 225 - 230
  • [26] EFFECT OF HEADER ON LATENT HEAT RECOVERY HEAT EXCHANGER
    Osakabe, Masahiro
    PROCEEDINGS OF THE ASME POWER CONFERENCE - 2011, VOL 1, 2012, : 457 - 463
  • [27] Development of heat exchanger for heat recovery of process gases
    Sysoev, I. A.
    Sysoeva, T. I.
    Kondrat'ev, V. V.
    Kolmogortsev, I. V.
    Kolosov, A. D.
    Ershov, V. A.
    INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING, AUTOMATION AND CONTROL SYSTEMS 2018, 2019, 560
  • [28] Modeling non-uniform frost growth on a fin-and-tube heat exchanger
    Padhmanabhan, S. K.
    Fisher, D. E.
    Cremaschi, L.
    Moallem, E.
    INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2011, 34 (08): : 2018 - 2030
  • [29] Heat Pipe Finned Heat Exchanger for Heat Recovery: Experimental Results and Modeling
    Righetti, Giulia
    Zilio, Claudio
    Mancin, Simone
    Longo, Giovanni A.
    HEAT TRANSFER ENGINEERING, 2018, 39 (12) : 1011 - 1023
  • [30] Energy efficient heat pipe heat exchanger for waste heat recovery in buildings
    Burlacu, Andrei
    Sosoi, Gavril
    Vizitiu, Robert Stefan
    Barbuta, Marinela
    Lazarescu, Constantin Doru
    Ciocan, Vasilica
    Serbanoiu, Adrian Alexandru
    11TH INTERNATIONAL CONFERENCE INTERDISCIPLINARITY IN ENGINEERING, INTER-ENG 2017, 2018, 22 : 714 - 721