Numerical simulation study on hot pressing of ceramic/metal powders

This study utilizes the multi-particle finite element method (MPFEM) to establish 2D and 3D hot pressing models for particle-reinforced aluminum matrix composites. The hot pressing of 6061Al powder and 10 % volume fraction SiCp/6061Al composite powder are simulated under a temperature range of 430-510 degrees C and pressures ranging from 15 to 30 MPa. The densification mechanism of the composites is elucidated by analyzing the evolution of density and microscopic particle behavior. The analysis reveals that elevating both the pressing temperature and pressure effectively increases the relative density of the powders, with the maximum growth rate occurring at 25 MPa. Notably, the barrier effect created by SiC particles in the 6061Al matrix restricts the plastic deformation and flow of matrix particles, leading to a lower final relative density for the composite powder compared to pure 6061Al powder. Microscopic observations indicate that particle rearrangement dominates in the initial pressing stage, while plastic deformation and particle flow become crucial factors for enhancing relative density in the later stage. Further stress-strain analysis demonstrates that 6061Al particles effectively fill pores through plastic deformation, resulting in stress concentration primarily on the harder SiC particles.