Improving the reactor safety aspects by the implementation of (Th-U 233-Pu) fuel in a PWR assembly

被引:1
|
作者
Mustafa, Sayed Saeed [1 ]
机构
[1] Zagazig Univ, Fac Sci, Zagazig, Egypt
关键词
THORIUM-BASED FUELS; PRESSURIZED-WATER REACTOR; ECONOMICS; BEHAVIOR; FISSILE; DESIGN; CYCLES; PU;
D O I
10.1016/j.nucengdes.2024.113147
中图分类号
TL [原子能技术]; O571 [原子核物理学];
学科分类号
0827 ; 082701 ;
摘要
The aim of this work is not only to demonstrate how to introduce thorium as an alternative nuclear fuel into pressurized water reactors, but also to examine the several advantages that (Th, U 233 , Pu) has over (Th, U 233 ) and (Th, Pu) fuels when (U 233 O 2 ) is mixed with (Th-Pu)O 2 fuel. To investigate these advantages, three thorium fuels, (Th, U 233 ), (Th-U 233 -Pu) and (Th-Pu) are simulated and analyzed by the MCNPX 2.7 code. The reactor safety aspects of these fuels are compared with those of the reference UO 2 fuel. The concentration of Th-233 and fissile isotopes is adjusted to obtain criticality (Keff = 1.03) at the same burnup value (35 GWd/ tonne) for all fuel types. Based on the predicted results, the author revealed that: 1) 56 % of plutonium (238-242) is depleted in the case of (Th-U 233 -Pu), while 41 % of plutonium is depleted in the (Th-Pu) at 60 GWd/tonne. This result indicates that (Th-U 233 -Pu) is more proliferation -resistant than (Th-Pu). 2) In terms of improving the quantity of radioactive waste, (Th, U 233 , Pu) model produces 0.6 and 0.9 times the amount of Am (241-243) and Cm (242-244) in UO 2 , respectively. On the other hand, (Th, Pu) fuel produces about 7 times the amount of Am and 8 times the amount of Cm in UO 2 fuel. 3) The fuel temperature coefficient (FTC) and moderator temperature coefficient (MTC) of (Th-U 233 -Pu) are more negative than that of UO 2 and (Th-U 233 ) at the early stages of fuel burnup (0 - 5) GWd/tonne.4) the total mass of fissile isotopes in (Th-U 233 -Pu) is greater than that of UO 2 and (Th-U 233 ) and as a result, the fuel life time is longer in the case of (Th-U 233 -Pu). 4) The conversion ratio provided by (Th-U 233 -Pu) is greater than that provided by UO 2 and (Th-U 233 ).This behavior is expected owing to the hardening of neutron spectrum in (Th-U 233 - Pu). 5) The peaking factors are lower in the case of (Th-U 233 -Pu) compared to (Th-Pu). 6) The concentration of xenon and samarium is noticeably lower for (Th-U 233 - Pu) in comparison with (Th-Pu) and consequently, the time required for restarting the reactor is accelerated.
引用
收藏
页数:29
相关论文
共 40 条
  • [21] Influences of 7Li enrichment on Th-U fuel breeding for an Improved Molten Salt Fast Reactor(IMSFR)
    Guang-Chao Li
    Yang Zou
    Cheng-Gang Yu
    Jian-Long Han
    Jin-Gen Chen
    Hong-Jie Xu
    Nuclear Science and Techniques, 2017, 28 (07) : 104 - 112
  • [22] Neutronic Behavior Evaluation of An Accelerator Driven Subcritical Reactor Based on Th-U Fuel Cycle using Computational Method
    Feghhi, S. A. H.
    Gholamzadeh, Z.
    Tenreiro, C.
    Kim, H.
    2013 IEEE NUCLEAR SCIENCE SYMPOSIUM AND MEDICAL IMAGING CONFERENCE (NSS/MIC), 2013,
  • [23] Optimization of Th-U fuel breeding based on a single-fluid double-zone thorium molten salt reactor
    Li, G. C.
    Cong, P.
    Yu, C. G.
    Zou, Y.
    Sun, J. Y.
    Chen, J. G.
    Xu, H. J.
    PROGRESS IN NUCLEAR ENERGY, 2018, 108 : 144 - 151
  • [24] Neutronic feasibility study of (Th - 233U)-ZrH1.65 fuel in a modelled TRIGA research reactor
    El Banni, Fadi
    Kabach, Ouadie
    Koua, Aka A.
    Gogon, Bogbe L. H.
    Monnehan, Georges A.
    Benchrif, Abdelfettah
    Amsil, Hamid
    Chetaine, Abdelouahed
    JOURNAL OF KING SAUD UNIVERSITY SCIENCE, 2022, 34 (02)
  • [25] High conversion Th-U233 fuel for current generation of PWRs: Part I - Assembly level analysis
    Baldova, D.
    Fridman, E.
    Shwageraus, E.
    ANNALS OF NUCLEAR ENERGY, 2014, 73 : 552 - 559
  • [26] The use of (Th, U, Pu)O2 fuel in a water water energy reactor (WWER-1000)
    Ukhov, AA
    Kriger, SV
    MODERN TECHNIQUES AND TECHNOLOGY: MTT' 2000, 2000, : 18 - 20
  • [27] Thermohydraulic evaluation of a MOX (U, Th)O2fuel application in an AP1000 reactor typical fuel assembly
    Da Cunha C.J.C.M.R.
    De Andrade Lima F.R.
    Rodríguez D.G.
    Da Cunha, Caio Július César Miranda Rodrigues (caio.julius@ufpe.br), 1600, Inderscience Publishers (14): : 97 - 113
  • [28] Quantification of Uncertainties due to 235,238U, 239,240,241Pu and Fission Products Nuclear Data Uncertainties for a PWR Fuel Assembly
    da Cruz, D. F.
    Rochman, D.
    Koning, A. J.
    NUCLEAR DATA SHEETS, 2014, 118 : 531 - 534
  • [29] Mass balance analysis of Th-233U based MSR (Molten-Salt Reactor) cycle (THORIMS-NES) transferred from present U-Pu based LWRs (Light Water Reactor)
    Kamei, Takashi
    Furukawa, Kazuo
    Mitachi, Koshi
    Kato, Yoshio
    ENERGY, 2010, 35 (02) : 928 - 934
  • [30] Comparison of (Th-233U) O2 and (Th-235U) O2 fuel burn up into a thermal research reactor using MCNPX 2.6 code
    Feghhi, S. A. H.
    Gholamzadeh, Z.
    Soltani, L.
    Tenreiro, C.
    INTERNATIONAL JOURNAL OF RADIATION RESEARCH, 2013, 11 (01): : 29 - 33