Reverse Engineering of Building Layout Plan through Checking the Setting out of a Building on a Site Using 3D Laser Scanning Technology for Sustainable Building Construction: A Case Study

Among smart construction technologies, 3D laser scanning technology is used in a variety of applications, including progress measurement, quantity management, reverse engineering (RE), health monitoring, mechanical electronic plumbing (MEP), and so on, using point clouds data (PCD) in the architecture, engineering, and construction (AEC) field. This technology is one of the important data acquisition technologies in construction status to perform active project management through the complete and accurate three-dimensional and visual judgment of building acts. The surveying work for setting out a building is the first step in constructing a building; the location of the building must match the design plan for a building to be sustainable. This is because, if a location deviation exceeds the permitted range, the building must be demolished and rebuilt. When this happens, sustainable construction management is impossible due to delays in the construction schedule, increased construction costs, waste generation, and so on. The purpose of this study is to investigate a case where the accuracy of setting out a building was measured in the construction stage of a building and the building layout design was modified by RE. Although the foundation construction of the case building was in progress, it was confirmed that the setting out of the building measured using a 3D laser scanner did not match with the building layout plan. Therefore, there was no legal problem even if the layout plan is modified according to the measured results, so the building layout plan was modified through RE. Consequently, it was confirmed that a case building under construction became sustainable through RE, and that sustainable construction management was possible by preventing construction schedule delays, increased construction costs, and waste generation.