Effect of Citrate-Based Bath pH on Properties of Electrodeposited Cu-Zn Coating on an Aluminum Substrate

被引:0
|
作者
Ozdemir, Rasim [1 ]
Unal, Ersin [2 ]
Karahan, IsmaIl Hakki [3 ]
机构
[1] Kilis 7 Aralik Univ, Vocat Sch Tech Sci, TR-79000 Kilis, Turkiye
[2] Osmaniye Korkut Ata Univ, Fac Engn & Nat Sci, Dept Mech Engn, TR-80000 Osmaniye, Turkiye
[3] Univ Mustafa Kemal, Fac Arts & Sci, Dept Phys, TR-31040 Hatay, Turkiye
关键词
ZINC ELECTRODEPOSITION; ELECTRICAL-RESISTIVITY; NANOCOMPOSITE COATINGS; COPPER-ZINC; ALLOY; FABRICATION; CORROSION; FILMS; TIN; MICROSTRUCTURE;
D O I
10.1007/s11661-024-07524-3
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
In this study, Cu-Zn alloys were deposited in citrate-based electrolytes on aluminum substrate by electrodeposition method. The effect of bath pH variation on the properties of the obtained Cu-Zn alloy coatings was investigated. The electrochemical behavior of the citrate-based baths and the crystalline structure, surface morphology and elemental content, electrical resistivity and thermal behavior of the alloy coatings were analyzed. According to the results of cyclic voltammetry (CV) analysis, increasing bath pH caused a negative shift in the cathodic deposition potential. In addition, the anodic dissolution peaks first shifted to the positive side with increasing pH and then shifted back to the negative direction. According to the results of XRD analysis, the phase structure of Cu-Zn alloys generally consists of alpha and beta ' phases, but according to differential scanning calorimeter (DSC) analysis, it is possible that there is a gamma phase in the structure in addition to these phases. In addition, pH increase (4.5 to 6.5) caused a relative increase in crystal grain size (similar to 14 to similar to 25 nm). The Zn content of Cu-Zn coatings first increased (similar to pct 15 to similar to pct 55) with pH increase, then followed a horizontal trend (similar to pct 55 to similar to pct 59) with further pH increase and then exhibited a slight decreasing trend (similar to pct 59 to similar to pct 52). The pH increase significantly affected the surface morphology of the coatings and denser coatings were obtained with increasing pH. While the electrical resistivity of Cu-Zn coatings first increased (0.0408 to 0.0696 mu Omega cm for 297 K) with increasing pH, it tended to decrease (0.0696 to 0.0479 mu Omega cm for 297 K) again at higher pH values. In addition, the electrical resistivity of the coatings increased with increasing measurement temperature. According to DSC analysis of the coatings, endothermic peaks were obtained, possibly representing the transformation from gamma to beta ' phase. [GRAPHICS] . (c) The Author(s) 2024
引用
收藏
页码:3937 / 3955
页数:19
相关论文
共 50 条
  • [21] The effect of molecular structure of imidazole-based compounds on corrosion inhibition of Cu, Zn, and Cu-Zn alloys
    Milosev, Ingrid
    Taheri, Peyman
    Kapun, Barbara
    Kozlica, Dzevad K.
    Mol, Arjan
    Kokalj, Anton
    CORROSION SCIENCE, 2024, 240
  • [22] Preliminary study of pH effect in the application of Langmuir and Freundlich isotherms to Cu-Zn competitive adsorption
    Mesquita, ME
    Silva, JMVE
    GEODERMA, 2002, 106 (3-4) : 219 - 234
  • [23] Corrosion properties of ceria-based coating electrodeposited from alkaline bath on electrogalvanized steel
    F. Rouabhia
    Y. Hamlaoui
    A. Meroufel
    F. Pedraza
    Journal of Applied Electrochemistry, 2021, 51 : 567 - 580
  • [24] Corrosion properties of ceria-based coating electrodeposited from alkaline bath on electrogalvanized steel
    Rouabhia, F.
    Hamlaoui, Y.
    Meroufel, A.
    Pedraza, F.
    JOURNAL OF APPLIED ELECTROCHEMISTRY, 2021, 51 (04) : 567 - 580
  • [25] Application of Langmuir and Freundlich isotherms to Cu-Zn competitive adsorption in two soils. Effect of pH
    Mesquita, ME
    AGROCHIMICA, 2001, 45 (1-2): : 32 - 45
  • [26] Effect of Bath pH Value on Magnetic Properties of Electrodeposited Co-Pt-W Thin Films
    Wei Guoying
    Ge Hongliang
    Wu Qiong
    Yu Yundan
    RARE METAL MATERIALS AND ENGINEERING, 2010, 39 : 57 - 60
  • [27] Microstructure and adhesion strength of NiAl coating prepared on Q235 substrate by combustion synthesis assisted with Cu-Zn interlayer
    Li, Lei
    Wang, Langping
    Zhao, Likai
    Wang, Xiaofeng
    SURFACE & COATINGS TECHNOLOGY, 2018, 344 : 564 - 571
  • [28] Effect of [Zn2+]/[Cu2+] ratio of the bath on the composition and property of Cu-Zn alloy micropillars prepared using microanode-guided electroplating
    Wang, Chun-Yao
    Tseng, Yao-Tien
    Lin, Jing-Chie
    Ciou, Yong-Jie
    Hwang, Yean-Ren
    ELECTROCHIMICA ACTA, 2021, 375
  • [29] First-principles calculation of elastic properties of Cu-Zn intermetallic compounds for improving the stiffness of aluminum alloys
    Iwaoka, Hideaki
    Hirosawa, Shoichi
    COMPUTATIONAL MATERIALS SCIENCE, 2020, 174
  • [30] Effect of NiFe layer thickness on properties of NiFe/Cu superlattices electrodeposited on titanium substrate
    Hilal Kuru
    Nuray Çolak Aytekin
    Hakan Köçkar
    Mürşide Haciismailoğlu
    Mürsel Alper
    Journal of Materials Science: Materials in Electronics, 2019, 30 : 17879 - 17889