Study of Microstructure, Phase Composition and Oxidation Resistance of High-Entropy Alloys Al0.25CoCrFeNi and Al0.25CoCrFeNiCuAgx (x=0, 0.1, 0.2)

被引：0

作者：

Samoilova, O. V. ^{[1
]}

Suleymanova, I. I. ^{[1
]}

Shaburova, N. A. ^{[1
]}

Trofimov, E. A. ^{[1
]}

机构：

[1] South Ural State Univ Natl Res Univ, Chelyabinsk 454080, Russia

来源：

INORGANIC MATERIALS-APPLIED RESEARCH | 2024年 / 15卷 / 04期

基金：

俄罗斯科学基金会;

关键词：

high-entropy alloys; high-temperature oxidation; kinetic curves; oxide film; copper; silver; ALXCOCRFENIM M; BEHAVIOR; TEMPERATURE; CU; TI;

D O I：

10.1134/S2075113324700643

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The microstructure, phase composition, and oxidation resistance of as-cast high-entropy alloys (HEAs) Al0.25CoCrFeNi and Al0.25CoCrFeNiCuAgx (x = 0, 0.1, 0.2) have been studied. Oxidation was carried out at 700 degrees C for 50 h in air. During the experiment, curves for the dependence of the specific weight gain on the exposure time were plotted. It has been shown that the introduction of copper has a slight effect on the resistance of the base Al0.25CoCrFeNi HEA to oxidation, while additional (to copper) alloying with silver worsens the resistance of the samples to high-temperature gas corrosion.

引用

页码：1091 / 1099

页数：9

共 50 条

[31] Microstructure and wear resistance of an intermetallic-based Al0.25Ti0.75CoCrFeNi high entropy alloy
Gwalani, Bharat
Ayyagari, Aditya V.
Choudhuri, Deep
Scharf, Thomas
Mukherjee, Sundeep
Gibson, Mark
Banerjee, Rajarshi
MATERIALS CHEMISTRY AND PHYSICS, 2018, 210 : 197 - 206
[32] Interplay of crystallographic orientation and density on gamma-ray shielding properties: A case study of the Al0.25CoCrFeNi high entropy alloy
Khattari, Z. Y.
MATERIALS TODAY COMMUNICATIONS, 2025, 42
[33] Mechanical properties and deformation mechanisms of Al0.1 CoCrFeNi high-entropy alloys
Chen Gang
Wang Lu
Yang Jing
Li Qiang
Lyu Pin
Ma Sheng-guo
CAILIAO GONGCHENG-JOURNAL OF MATERIALS ENGINEERING, 2019, 47 (01): : 106 - 111
[34] Theoretical investigation on the elastic and mechanical properties of high-entropy alloys with partial replacement of Sc in Hf0.25Ti0.25Zr0.25Sc0.25-x Al x (x=15?%)
Maddheshiya, Ajit Kumar
Singh, Shakti Pratap
Singh, Devraj
Yadav, Phool Singh
Yadav, Raja Ram
Yadav, Thakur Prasad
ZEITSCHRIFT FUR NATURFORSCHUNG SECTION A-A JOURNAL OF PHYSICAL SCIENCES, 2023, 78 (11): : 1051 - 1059
[35] High temperature oxidation resistance of Al0.25CoCrFeNiMn and Al0.45CoCrFeNiSi0.45 high entropy alloys
Moghaddam, Ahmad Ostovari
Shaburova, Nataliya Aleksandrovna
Sudarikov, Mikhail Viktorovich
Veselkov, Sergey Nikolaevich
Samoilova, Olga Vladimirovna
Trofimov, Evgeny Alekseevich
VACUUM, 2021, 192
[36] An initio study of influence of substitution of Sc with Al on intrinsic mechanical properties of hexagonal high-entropy alloys Hf0.25Ti0.25Zr0.25Sc0.25- xAlx (x ≤ 15%)
Duan, Jia-Ming
Shao, Lin
Fan, Tou-Wen
Chen, Xiao-Tao
Tang, Bi-Yu
MATERIALS TODAY COMMUNICATIONS, 2021, 29
[37] Effect of particle content on microstructure and deformation mechanism of in-situ Al2O3p/Al0.25CoCrFeNi high entropy alloy matrix composites
Xu, Tuo
Zhuang, Wenchen
Meng, Suhui
Ma, Zheng
Jiang, Li
Wang, Tongmin
Cao, Zhiqiang
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 2025, 36 : 1835 - 1847
[38] Effects of Ti Content on the Microstructure and Mechanical Properties of Al0.2CoCrFeNi2Tix High-Entropy Alloys
Yang, Fan
Fu, Wenqing
Jian, Menglu
Hu, Qiannan
Liu, Min
Li, Guangshi
Wang, Zhanyong
Li, Fangjie
Shen, Qin
METALS AND MATERIALS INTERNATIONAL, 2024, : 981 - 993
[39] Dry Sliding Wear Behavior of Al0.4FeCrNiCox(x=0, 0.25, 0.5, 1.0 mol) High-Entropy Alloys
Kumar, Saurav
Patnaik, Amar
Pradhan, Ajaya Kumar
Kumar, Vinod
METALLOGRAPHY MICROSTRUCTURE AND ANALYSIS, 2019, 8 (04) : 545 - 557
[40] Dry Sliding Wear Behavior of Al0.4FeCrNiCox(x = 0, 0.25, 0.5, 1.0 mol) High-Entropy Alloys
Saurav Kumar
Amar Patnaik
Ajaya Kumar Pradhan
Vinod Kumar
Metallography, Microstructure, and Analysis, 2019, 8 : 545 - 557

← 1 2 3 4 5 →