Wear properties of nanosilica filled epoxy polymers and FRP composites

被引：0

作者：

Jumahat, A. ^{[1
]}

Kasolang, S. ^{[1
]}

Bahari, M. T. ^{[1
]}

机构：

[1] Univ Teknol MARA, Fac Mech Engn, Shah Alam 40450, Selangor, Malaysia

来源：

JURNAL TRIBOLOGI | 2015年 / 6卷

关键词：

Specific wear rate; Epoxy; Nanosilica; Fiber glass; Dry sliding; Slurry test;

D O I：

暂无

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

This paper is aimed to determine the wear properties of nanosilica filled epoxy polymers and FRP composites. Woven fiberglass has been deployed as the reinforcement material. The fibers were mixed with three different percentages of nanosilica-modified epoxy resin, i.e: 5wt%; 13wt%; 25wt%, in order to fabricate the desired samples of FRP composites. The effect of nanosilica on wear properties was evaluated using dry sliding wear and slurry tests. The results show that increasing the amount of nanosilica content has reduced the amount of accumulated mass loss. It was found that the FRP laminates with 25wt% of nanosilica have the highest wear resistance. The nanosilica filled fiber reinforced polymer composites have a high potential in tribological application such as ball bearing housing and snow sleds.

引用

页码：24 / 36

页数：13

共 50 条

[31] Dynamical properties of epoxy composites filled with quartz powder
Goyanes, S.N., 1600, Elsevier Sequoia SA, Lausanne, Switzerland (310):
[32] Thermogravimetry analysis of nanosilica-filled epoxy polymer
Jumahat, A.
Zamani, N. R.
Soutis, C.
Roseley, N. R. N.
MATERIALS RESEARCH INNOVATIONS, 2014, 18 : 279 - 284
[33] Friction and wear properties of PTFE composites filled with CNTs
College of Engineering, Nanjing Agricultural University, Nanjing 210031, China
Run Hua Yu Mi Feng, 2006, 12 (110-112):
[34] Investigation of wear properties of quartz filled polyester composites
Ates, Ergun
JOURNAL OF THE FACULTY OF ENGINEERING AND ARCHITECTURE OF GAZI UNIVERSITY, 2021, 36 (03): : 1230 - 1240
[35] Mechanical and anticorrosion properties of nanosilica-filled epoxy-resin composite coatings
Conradi, M.
Kocijan, A.
Kek-Merl, D.
Zorko, M.
Verpoest, I.
APPLIED SURFACE SCIENCE, 2014, 292 : 432 - 437
[36] Influence of the curing temperature in the mechanical and thermal properties of nanosilica filled epoxy resin coating
Pascual-Sánchez, V
Martín-Martínez, JM
MACROMOLECULAR SYMPOSIA, 2006, 233 : 137 - 146
[37] Dry Sliding Wear Behavior of Cast Iron Powder Filled Epoxy Composites
Mudradi, Sudheer
EMERGING TRENDS IN MECHANICAL ENGINEERING 2018, 2019, 2080
[38] Mechanical properties of epoxy composites reinforced with a low volume fraction of nanosilica fillers
Conradi, M.
Zorko, M.
Kocijan, A.
Verpoest, I.
MATERIALS CHEMISTRY AND PHYSICS, 2013, 137 (03) : 910 - 915
[39] Abrasive wear of epoxy composites filled by abrasive particles and reinforced by polyamide fibres
Mohamed, M. K.
Abdel-Jaber, G. T.
Ali, W. Y.
MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, 2014, 45 (02) : 123 - 129
[40] Mechanical and wear characteristics of epoxy composites filled with industrial wastes: A comparative study
Purohit, A.
Satapathy, A.
NATIONAL CONFERENCE ON PROCESSING AND CHARACTERIZATION OF MATERIALS (NCPCM), 2017, 178

← 1 2 3 4 5 →