3D transient MHD simulation of DC breaking vacuum arc based on artificial current zero

In the vacuum DC circuit breaker based on the artificial current zero, the change of arc luminosity delays the change of current value significantly in the fast current-zero stage. This phenomenon has impacts on the breaking capacity of the DC vacuum circuit breaker. Therefore, it is necessary to study the dynamic characteristics of the arc plasma under the above condition. In this work, a 3D transient magneto-hydro-dynamic model based on the commercial cup-type axial magnetic field (AMF) contact is established to study this phenomenon. The simulation results show that the fast current-zero stage is too short for the plasma to diffuse. The changes of the physical characteristics of the arc plasma lag the change of current value. Moreover, the magnetic field hysteresis caused by the eddy current on the electrode occurs in this stage, resulting in a continuous stronger AMF. It makes the distributions of the plasma uniform, while the diffusion of the arc plasma reduced at low currents, which is detrimental to the post-arc dielectric recovery stage. In addition, in the fast current-zero stage, the AMF near the contact slot is smaller than in other areas. This indicates that the slotting is effective in suppressing eddy currents and avoiding the negative effect of excessive AMF on plasma diffusion at this stage. The simulation results are consistent with the experimental results. Published under an exclusive license by AIP Publishing.