Surface and core hole effects in X-ray photoelectron spectroscopy

In XPS analysis, two effects, which significantly reduce the measured peak intensity, are usually neglected: the core hole left behind in an XPS process which causes "intrinsic" excitations and excitations as the photoelectron pass through the surface region. We have calculated these effects quantitatively for various energies, geometries, and materials. Instead of considering the two effects separately, we introduce a new parameter, namely the correction parameter for XPS or CP(xps), which takes into account both effects. We define this CP(xps) as the change in probability for emission of a photoelectron caused by the presence of the surface and the core hole in comparison with the situation where the core hole is neglected and the electron travels the same distance in an infinite medium. The calculations are performed within the dielectric response theory by means of the QUEELS-XPS software determining the energy-differential inelastic electron scattering cross-sections for X-ray photoelectron spectroscopy (XPS) including surface and core hole effects. This study has been carried out for electron energies between 300 eV and 3400 eV, for angles to the surface normal between 0 degrees and 60 degrees and for various materials. We find that the absolute effect is a reduction by 35-45% in peak intensities but that the variation in CP(xps) with material, angle and energy are < +/- 10% for emission angle <= 60 degrees and photoelectron energy <= 1500 eV. This implies that when XPS analysis is done using relative intensities, the combined effect of the surface and of the core hole is typically less than approximate to +/- 10% for geometries and energies normally used in XPS. In practice, it is however difficult to determine the bare peak intensity without the intrinsic electrons because the two overlap in energy. (C) 2010 Elsevier B.V. All rights reserved.