The step-edge type HTS rf SQUID coupling with a LC circuit in ultra-low field NMR system

The step-edge type high temperature superconductor (HTS) radio frequency (rf) superconducting quantum interference devices (SQUIDs) were fabricated from YBa2Cu3O7-delta thin films with a field sensitivity of 66 fT/Hz(1/2). Even though the sensitivity of the rf SQUID sensor used in the experiments was degraded to 77 fT/Hz(1/2) in the magnetic shielded room (MSR), the performance of the rf SQUID sensor was good enough for the ultra-low field (ULF) nuclear magnetic resonance (NMR) experiments at a measurement field of 61.5 mu T. With the help of a strictly controlled fast switching circuit and a coupled LC circuit which acted as flux transformer, the signal-tonoise ratio (SNR) of the rf SQUID-based ULF NMR system with different operating points was measured. The optimum SNR was 40 dB which increased significantly by coupling an input coil closely beneath the rf SQUID sensor. The extracted 1/T-1 value for pure water sample at 23 degrees C showed the rf SQUID based ULF NMR was an effective system for ULF NMR researches. All above, the direct coupled method and the control circuit show a great potential in the future rf SQUID-based ULF NMR &MRI system.