Effect of Sintering Additive Composition on the Mechanical and Tribological Properties of Si3N4/SiC Ceramics

被引：0
|
作者：
Hu Hai-Long [1 ,2 ]
Zeng Yu-Ping [1 ]
Zuo Kai-Hui [1 ]
Xia Yong-Feng [1 ]
Yao Dong-Xu [1 ]
机构：
[1] Chinese Acad Sci, Shanghai Inst Ceram, State Key Lab High Performance Ceram & Superfine, Shanghai 200050, Peoples R China
[2] Univ Chinese Acad Sci, Beijing 100864, Peoples R China
来源：
JOURNAL OF INORGANIC MATERIALS | 2014年 / 29卷 / 08期
关键词：
Si3N4/SiC ceramics; sintering additive; flexural strength; tribological properties; SILICON-NITRIDE CERAMICS; WEAR BEHAVIOR; ABRASIVE WEAR; MICROSTRUCTURE; FABRICATION; ALUMINA;
D O I：
暂无
中图分类号：
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
Two compositions of the Y2O3-Al2O3 (YA) and Y2O3-MgO (YM) systems were chosen to investigate the effect of sintering additive composition on the mechanical and tribological properties of gas pressure sintered Si3N4/SiC ceramics. The relative density, flexural strength, fracture toughness, hardness, coefficient of friction and wear rate were verified to depend substantially on the sintering additive composition. Compared with YM, the Si3N4/SiC ceramics with YA exhibit superior sinterability and show preferable mechanical and tribological properties, especially for the Si3N4/SiC ceramics with 20wt% SiC addition. These properties can be primarily attributed to the higher relative density and the grain size with smaller aspect ratio.
引用
收藏
页码：885 / 890
页数：6
相关论文
共 21 条
  • [1] Wear of aligned silicon nitride under dry sliding conditions
    Belmonte, M.
    Miranzo, P.
    Osendi, M. I.
    Gomes, J. R.
    [J]. WEAR, 2009, 266 (1-2) : 6 - 12
  • [2] Microstructure and abrasive wear in silicon nitride ceramics
    Doǧan, C.P.
    Hawk, J.A.
    [J]. Wear, 2001, 250-251 (PART 1) : 256 - 263
  • [3] WEAR TRANSITION DIAGRAM FOR SILICON-NITRIDE
    DONG, X
    JAHANMIR, S
    [J]. WEAR, 1993, 165 (02) : 169 - 180
  • [4] THE COMBINED EFFECT OF SPEED AND HUMIDITY ON THE WEAR AND FRICTION OF SILICON-NITRIDE
    GEE, MG
    BUTTERFIELD, D
    [J]. WEAR, 1993, 162 (pt A) : 234 - 245
  • [5] Tribological characteristics of self-mated couples of Si3N4-SiC composites in the range 22-700°C
    Gomes, JR
    Osendi, MI
    Miranzo, P
    Oliveira, FJ
    Silva, RF
    [J]. WEAR, 1999, 233 : 222 - 228
  • [6] Herrmann M, 1998, J AM CERAM SOC, V81, P1095, DOI 10.1111/j.1151-2916.1998.tb02456.x
  • [7] Low-cost preparation of Si3N4-SiC micro/nano composites by in-situ carbothermal reduction of silica in silicon nitride matrix
    Hnatko, M
    Galusek, D
    Sajgalík, P
    [J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2004, 24 (02) : 189 - 195
  • [8] Influence of rare-earth additives on wear properties of hot-pressed silicon nitride ceramics under dry sliding conditions
    Hyuga, H
    Jones, MI
    Hirao, K
    Yamauchi, Y
    [J]. JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2004, 87 (09) : 1683 - 1686
  • [9] Microstructure and fracture-mechanical properties of carbon derived Si3N4+SiC nanornaterials
    Kasiarová, M
    Dusza, J
    Hnatko, M
    Sajgalik, P
    [J]. MATERIALS SCIENCE & ENGINEERING C-BIOMIMETIC AND SUPRAMOLECULAR SYSTEMS, 2006, 26 (5-7): : 862 - 866
  • [10] Some tribological properties of a carbon-derived Si3N4/SiC nanocomposite
    Kasiarová, M
    Rudnayová, E
    Dusza, J
    Hnatko, M
    Sajgalík, P
    Merstallinger, A
    Kuzsella, L
    [J]. JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2004, 24 (12) : 3431 - 3435
123