Drag prediction for the DLR-F6 wing-body configuration using the edge solver

Numerical investigations are reported on the DLR-F6 wing-body configuration with and without fairing. The configurations have been adopted as test cases for the Third AIAA Drag Prediction Workshop. The addition of the fairing is to eliminate the flow separation bubble in the junction between the wing trailing edge and the fuselage. The computations have been carried out using two groups of unstructured grids with different sizes. In addition to the effect of incidences, studies of grid convergence have also been performed. The computational fluid dynamics solver Edge is used for the investigation. The calculations confirm that the flow separation can be removed in the wing-fuselage junction with the fairing. For this configuration, the results obtained with the two groups of grid are very similar. Without fairing, however, one group of grids has pronounced a lower lift and produced a more extended trailing-edge separation. Because no experimental data are available for the flow condition as specified in Drag Prediction Workshop-3, additional calculations have been carried out with the clean wing-body configuration at the Drag Prediction Workshop-2 Reynolds number to validate the numerical results against available experimental data. Very good agreement is obtained, in particular, for the global forces and moments. The calculation indicates that, as compared with experimental data, the grid which predicts a relatively large separation region provides improved predictions.