Reconfigurable All-band GNSS RF CMOS Receiver

This paper presents a fully integrated reconfigurable all-band RF receiver for GPS/GLONASS/Galileo/Compass in 55 nm CMOS. The receiver incorporates two RF front-ends and two IF channels (IFC) to process any two GNSS signals. A switching module (SWM) is integrated to provide the connectivity between different RF front-end and IFC, which will effectively simplify the design complexity of the IFC and save power consumption. A flexible frequency planning with two frequency synthesizers is utilized to achieve the reception of any two GNSS signals. Several digitally-assisted calibration modules are integrated to ensure that the chip performance only shows a weak PVT dependence. While drawing about 26-29.2 mA per channel from a 1.2 V supply, this RF receiver achieve an image rejection ratio (IMRR) of more than 49 dB, an automatic gain control (AGC) range of 88 dB, and an input-referred 1 dB compression point (IP1dB) of better than -25 dBm with a noise figure (NF) of about 2 dB. The whole receiver consumes an active die area of about 3.5 mm(2).