Evaluation Method of Balance Mismatch Using CMRR Measurement for Printed Circuit Board

被引：0
|
作者：
Shimazaki, Mutsumi [1 ]
Asai, Hideki [2 ]
机构：
[1] Mitsubishi Electr Corp, Corp Prod Engn Dept, Chiyoda Ku, Tokyo 1008310, Japan
[2] Shizuoka Univ, Res Inst Elect, Hamamatsu, Shizuoka 4328561, Japan
来源：
2014 INTERNATIONAL SYMPOSIUM ON ELECTROMAGNETIC COMPATIBILITY, TOKYO (EMC'14/TOKYO) | 2014年
关键词：
Balance Degree; CDF; CMRR; EMI;
D O I：
暂无
中图分类号：
TM [电工技术]; TN [电子技术、通信技术];
学科分类号：
0808 ; 0809 ;
摘要：
When a primary factor of common-mode noise is corresponding to mismatch of balance on the wiring, the balance degree may be obtained from CMRR (Common Mode Rejection Ratio) of the printed circuit board in the equipment. We calculated CDF(Current Division Factors) as balance degree of micro strip lines. And we showed relational expression of the balance degree and CMRR. By the CMRR measurement, the mismatch of balance between cable and substrate wiring can be evaluated quantitatively.
引用
收藏
页码：101 / 104
页数：4
相关论文
共 50 条
  • [1] Evaluation method of common-mode control using the CMRR in power distribution interconnection on printed circuit board
    1600, Japan Institute of Electronics Packaging (16):
  • [2] A Study of Estimation of Balance Degree Using CMRR Mesurement for Power Distribution Interconnection on Printed Circuit Board
    Shimazaki, Mutsumi
    Asai, Hideki
    2013 IEEE ELECTRICAL DESIGN OF ADVANCED PACKAGING AND SYSTEMS SYMPOSIUM (EDAPS), 2013, : 130 - 133
  • [3] Current measurement using printed circuit board coil
    Wydzgowski, L
    PHOTONICS APPLICATIONS IN ASTRONOMY, COMMUNICATIONS, INDUSTRY, AND HIGH-ENERGY PHYSICS EXPERIMENTS IV, 2006, 6159
  • [4] Printed Circuit Board Permittivity Measurement Using Waveguide and Resonator Rings
    't Land, Sjoerd Op
    Tereshchenko, Olga
    Ramdani, Mohamed
    Leferink, Frank
    Perdriau, Richard
    2014 INTERNATIONAL SYMPOSIUM ON ELECTROMAGNETIC COMPATIBILITY, TOKYO (EMC'14/TOKYO), 2014, : 777 - 780
  • [5] Evaluation of Heat Dissipation Performance of Printed Circuit Board Using JPCA Method in CFD Analysis
    Hatakeyama, Tomoyuki
    Kibushi, Risako
    Suzuki, Koichi
    Ishizuka, Masaru
    2018 13TH INTERNATIONAL MICROSYSTEMS, PACKAGING, ASSEMBLY AND CIRCUITS TECHNOLOGY CONFERENCE (IMPACT), 2018, : 97 - 100
  • [6] PRINTED CIRCUIT BOARD EVALUATION BY HOLOGRAPHIC INTERFEROMETRY
    LO, DS
    REVIEW OF SCIENTIFIC INSTRUMENTS, 1972, 43 (10): : 1498 - &
  • [7] Charge measurement using an array of Faraday's Cups on a printed circuit board
    Dastoori, K.
    Al-Shabaan, G.
    Kolhe, M.
    Thompson, D.
    Makin, B.
    MEASUREMENT, 2014, 47 : 116 - 119
  • [8] Measurement of permittivity of printed circuit board materials at RF
    Kim, JH
    Venkataseshaiah, C
    PROCEEDINGS OF THE 5TH INTERNATIONAL CONFERENCE ON PROPERTIES AND APPLICATIONS OF DIELECTRIC MATERIALS, VOLS 1 AND 2, 1997, : 1167 - 1170
  • [9] Two-Electrode ECG Measurement Circuit Using a Feed Forward CMRR Enhancement Method
    Jedari, Esrafil
    Rashidzadeh, Rashid
    Mirhassani, Mitra
    Ahmadi, Majid
    2017 IEEE 30TH CANADIAN CONFERENCE ON ELECTRICAL AND COMPUTER ENGINEERING (CCECE), 2017,
  • [10] Detection and Classification of Printed Circuit Board Defects Using Image Subtraction Method
    Kaur, Beant
    Kaur, Gurmeet
    Kaur, Amandeep
    2014 RECENT ADVANCES IN ENGINEERING AND COMPUTATIONAL SCIENCES (RAECS), 2014,
12345