The effect of reaction conditions on the composition of desilication product( DSP) formed under simulated Bayer conditions

被引:87
|
作者
Whittington, BI [1 ]
Fletcher, BL [1 ]
Talbot, C [1 ]
机构
[1] CSIRO, Div Minerals, AJ Parker CRC Hydromet, Bentley, WA 6102, Australia
关键词
D O I
10.1016/S0304-386X(98)00021-8
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
NaCl, Na2CO3 and Na2SO4 impurities present in Bayer liquors have a detrimental effect on the efficiency of the Bayer process. However, it is possible to remove these impurities by incorporation of these salts into Bayer-sodalite or cancrinite (SOD or CAN, ideal formulae Na-8(Al6Si6O24)X-2. yH(2)O; X-= Cl-, OH-, 1/2 CO32-, 1/2 SO42-, Al(OH)(4)(-)). The Bayer-SOD or CAN is subsequently discarded with the red mud waste. This paper examines the composition of SOD or CAN formed after pre-desilication (100 degrees C for 15 h) then digestion (150 degrees C/30 min, 175 degrees C/30 min, 250 degrees C/10 min) in sodium aluminate liquors containing added Na2SO4 (0-36 g/l) and/or Na2CO3 (6-42 g/l) and/or NaCl (0-18 g/l). The results suggest that the magnitude of anion incorporation into Bayer-SOD under pseudo-Bayer conditions follows the trend: OH- much less than Al(OH)(4)(-) < Cl- less than or equal to CO32- much less than SO42- and that the overall SOD anion content can be approximated by: [0.5 mol Cl-/6SiO(2) + 0.5 mol Al(OH)(4)(-)/6SiO(2) + moles CO32-/6SiO(2) + moles SO42-/6SiO(2)] approximate to 1.15 [two standard deviations (2 sigma) = 0.25]. Incorporation of SO42- into the SOD cages can best be modelled from the liquor Na2SO4,, concentration by a Freundlich-type isotherm of the form (DSP molar SO3/6ReSiO(2) ratio) = c(1)[Na2SO4](c2), where c(1) and c(2) are constants. By contrast, the concentrations of Cl- or CO32- incorporated into the SOD are quantitatively dependent on the concentrations of Na2SO4, Na2CO3 and NaCl present in the initial liquor. The concentration of Cl-, CO32- or SO42- in the SOD cages was observed to vary with digestion temperature. The mechanism responsible for this variation was studied. The results were found to be qualitatively consistent with a mechanism involving substantial anion incorporation during desilication at 100 degrees C, subsequent dissolution of some of this original DSP and reprecipitation of a DSP with a composition approximately reflecting the liquor composition and temperature during digestion. The amount of reprecipitated :DSP increases with temperature-experiments suggest a treatment at 150 degrees C/30 min results in approximate to 10% of the SOD dissolving then reprecipitating, while treatments at 175 degrees C/30 min or 250 degrees C/10 min result in approximate to 17% and approximate to 50% of the SOD reprecipitating, respectively. (C) 1998 Elsevier Science B.V. All rights reserved.
引用
收藏
页码:1 / 22
页数:22
相关论文
共 50 条
  • [1] The composition of DSP formed under predesilication and high temperature Bayer digestion conditions
    Smith, PG
    Pennifold, R
    Lwin, T
    Kane, A
    LIGHT METALS 2001, 2001, : 5 - 11
  • [2] Effect of Alkalinity on Zeolite LTN Formation under Bayer Process Pre-desilication Conditions
    Peng, Hong
    Vaughan, James
    Vogrin, John
    INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH, 2021, 60 (28) : 10119 - 10128
  • [3] The anion effect on sodium aluminosilicates formed under Bayer process digestion conditions
    Vogrin, John
    Santini, Talitha
    Peng, Hong
    Vaughan, James
    HYDROMETALLURGY, 2020, 192
  • [4] The effect of mechanical and thermal treatments on the dissolution kinetics of kaolinite in alkaline sodium aluminate solution under conditions typical to Bayer desilication
    Kasa, Eszter
    Baan, Kornelia
    Kasa, Zsolt
    Konya, Zoltan
    Kukovecz, Akos
    Palinko, Istvan
    Sipos, Pal
    Szabados, Marton
    APPLIED CLAY SCIENCE, 2022, 229
  • [5] Hydrothermal processing of duckweed: Effect of reaction conditions on product distribution and composition
    Duan, Peigao
    Chang, Zhoufan
    Xu, Yuping
    Bai, Xiujun
    Wang, Feng
    Zhang, Lei
    BIORESOURCE TECHNOLOGY, 2013, 135 : 710 - 719
  • [6] Formation of lime-containing desilication product (DSP) in the Bayer process: Factors influencing the laboratory modelling of DSP formation
    Whittington, B
    Fallows, T
    HYDROMETALLURGY, 1997, 45 (03) : 289 - 303
  • [7] Sodalite phases formed from kaolinite under bayer-type conditions
    Amorim Melo, Caio Cesar
    Aranha Paz, Simone Patricia
    Angelica, Romulo Simoes
    MATERIA-RIO DE JANEIRO, 2017, 22 (03):
  • [8] Analysis of mudcake structures formed under simulated borehole conditions
    Hartmann, Albert
    Ozerler, Mustafa
    Marx, Claus
    Neumann, Hans-Joachim
    SPE drilling engineering, 1988, 3 (04): : 395 - 402
  • [9] Reaction parameters of the Bunsen reaction under simulated recycling conditions
    Zhang, P.
    Xue, L.
    Lan, S.
    Guo, H.
    Chen, S.
    Wang, L.
    Xu, J.
    INTERNATIONAL JOURNAL OF HYDROGEN ENERGY, 2014, 39 (27) : 14565 - 14573
  • [10] Study of TATP: Influence of Reaction Conditions on Product Composition
    Matyas, Robert
    Pachman, Jiri
    PROPELLANTS EXPLOSIVES PYROTECHNICS, 2010, 35 (01) : 31 - 37