Characterization of Zr-Al-N films synthesized by a magnetron sputtering method

被引:36
|
作者
Makino, Y
Mori, M
Miyake, S
Saito, K
Asami, K
机构
[1] Osaka Univ, Joining & Welding Res Inst, Ibaraki 5670047, Japan
[2] Tohoku Univ, Inst Mat Res, LAM, Sendai, Miyagi 9808577, Japan
来源
SURFACE & COATINGS TECHNOLOGY | 2005年 / 193卷 / 1-3期
关键词
Zr-Al-N system; hardness; phase change; band parameters;
D O I
10.1016/j.surfcoat.2004.07.036
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Pseudobinary Zr-Al-N films were synthesized by an inductively combined rf-plasma-assisted magnetron sputtering for the purpose of examining the prediction on the phase change in the T (transition metal)-Al-N pseudobinary system based on band parameters. Phase change from B1 structure to B4 was not verified by XRD and FTIR methods. Microhardness of these films showed a maximum hardness of about 46 GPa at the content of 30% AlN and then decreased drastically to about 28 GPa at the content of 35% AlN. The AlN content for the drastic change showed good agreement with the critical content predicted based on band parameters. Under the assumption that the drastic change of microhardness corresponds to the B1-B4 phase change, it is interpreted that appearance of two XRD peaks near 2 theta=32 degrees and 2 theta=38 degrees is attributed to the formation of the Zr-Al-N films with B1 structure. On the other hand, single XRD peak 2 theta=38 degrees in the Zr-Al-N film with ZrN/AlN=65:35 is assigned to B4 phase. Further, the existence of some amount of the B4 phase in the Zr-Al-N film with ZrN/AlN=70:30-80:20 is suggested from broadness in XRD peaks. (c) 2004 Elsevier B.V. All rights reserved.
引用
收藏
页码:219 / 222
页数:4
相关论文
共 50 条
  • [1] Phase change of Zr-Al-N and Nb-Al-N films prepared by magnetron sputtering method
    Makino, Y.
    Saito, K.
    Murakami, Y.
    Asami, K.
    DESIGNING OF INTERFACIAL STRUCTURES IN ADVANCED MATERIALS AND THEIR JOINTS, 2007, 127 : 195 - +
  • [2] Deposition and characterization Zr-Al-N coatings prepared by magnetron sputtering for tribological applications
    Kumarasubramanian, R.
    Kumar, D. Dinesh
    Preetham, R. Muni Sai
    Reddy, P. Bharath Kumar
    MATERIALS TODAY-PROCEEDINGS, 2021, 44 : 3701 - 3706
  • [3] Preparation of reactive magnetron sputtered Zr-Al-N films and their properties
    Technology Research Institute, 2-7-1 Ayumino Izumi, 594-1157 Osaka, Japan
    Shinku/Journal of the Vacuum Society of Japan, 2002, 45 (06) : 525 - 527
  • [4] Characterization of Mo-Al-N nanocrystalline films synthesized by reactive magnetron sputtering
    Yang, J. F.
    Yuan, Z. G.
    Liu, Q.
    Wang, X. P.
    Fang, Q. F.
    MATERIALS RESEARCH BULLETIN, 2009, 44 (01) : 86 - 90
  • [5] Microstructure and nanohardness properties of Zr-Al-N and Zr-Cr-N thin films
    Lamni, R
    Sanjinés, R
    Parlinska-Wojtan, M
    Karimi, A
    Lévy, F
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2005, 23 (04): : 593 - 598
  • [6] Characterization of (Al, Si)N films deposited by balanced magnetron sputtering
    Liu, H.
    Tang, W.
    Hui, D.
    Hei, L.
    Lu, F.
    THIN SOLID FILMS, 2009, 517 (21) : 5988 - 5993
  • [7] Nanomechanical characterization of bioglass films synthesized by magnetron sputtering
    Popa, A. C.
    Marques, V. M. F.
    Stan, G. E.
    Husanu, M. A.
    Galca, A. C.
    Ghica, C.
    Tulyaganov, D. U.
    Lemos, A. F.
    Ferreira, J. M. F.
    THIN SOLID FILMS, 2014, 553 : 166 - 172
  • [8] Characterization of n-type ZnO:Al films grown by magnetron sputtering
    Chaabouni, F.
    Costa, L. C.
    Abaab, M.
    Monteiro, J.
    ADVANCED MATERIALS FORUM III, PTS 1 AND 2, 2006, 514-516 : 1358 - 1362
  • [9] Ti-Al-Si-N nanocrystalline composite films synthesized by reactive magnetron sputtering
    Dong, YS
    Mei, FH
    Hu, XP
    Li, GY
    Gu, MY
    MATERIALS LETTERS, 2005, 59 (2-3) : 171 - 174
  • [10] Characterization of W-Ta-N hard films synthesized by direct current magnetron sputtering
    Yang, J. F.
    Yuan, Z. G.
    Wang, X. P.
    Fang, Q. F.
    SURFACE & COATINGS TECHNOLOGY, 2013, 231 : 19 - 23