Influence of precursor molar concentration on the electrical and magnetic properties of synthesized MnS nanocrystals

MnS Nanocrystals have been synthesized with 1:1, 1:2 and 2:1 molar ratio of precursors using wet chemical method. The electrical and magnetic properties of as-synthesized MnS nanocrystals have been investigated using the impedance spectroscopy and vibrating sample magnetometer respectively. An increase in dielectric constant from 68.5 to 87.9 with increasing Mn content and decrease to 54.1 with increase in the sulfur content was observed. Both the dielectric constant and the loss factor increased with temperature due to the Maxwell-Wagner type interfacial space-charge polarization. The Cole-Cole plot confirmed that the conduction in as-synthesized samples are through the grain and grain boundaries. The resistance and capacitance of grain and grain boundaries have been calculated. The grain resistance varies from 248 to 199 Omega whereas the grain boundary resistance varies from 16 to 6.7 K Omega over the temperature ranges of 323-473 K for 1:1 sample. It endorsed the NTCR type behavior in all the samples. The electric modulus representation revealed the well-defined relaxation peaks. The relaxation time versus temperature behavior revealed that the relaxation time decreases with increase in temperature. AC-conductivity (sigma(ac)) increases with increasing frequency and temperature. sigma(ac) increases from 1.58 x 10(-5) to 1.51 x 10(-3) S cm(-1) with the increase of Mn content and then decreases to 1.22 x 10(-8) S cm(-1) with increase of sulfur content. The activation energy is found to be 0.35 eV (1:1), 0.64 eV (1:2) and 0.28 eV (2:1) at 3 kHz. The chemically modified MnS nanocrystals exhibit paramagnetic behavior. A typical saturation magnetization of 0.56, 0.38, and 0.57 emu/g and coercivity of 2.31, 8.42, and 5.57 Oe at room temperature for 1:1, 1:2 and 2:1 sample respectively.