A numerical study on concentration polarization in 3D cylindrical fluidized beds with vertically immersed membranes

被引:13
|
作者
Voncken, R. J. W. [1 ]
Roghair, I. [1 ]
Annaland, M. van Sint [1 ]
机构
[1] Eindhoven Univ Technol, Dept Chem Engn & Chem, Chem Proc Intensificat, POB 513, NL-5612 AZ Eindhoven, Netherlands
关键词
Concentration polarization; Mass transfer; Hydrodynamics; Fluidized bed; Membranes; Two-fluid model; CFD; DISCRETE PARTICLE SIMULATIONS; HEAT-TRANSFER; MASS-TRANSFER; FLOW MODELS; HYDRODYNAMICS; REACTORS; TUBE;
D O I
10.1016/j.ces.2019.05.010
中图分类号
TQ [化学工业];
学科分类号
0817 ;
摘要
Concentration polarization is a serious issue for systems in which high-flux, palladium-based, hydrogen perm-selective membranes are used to extract hydrogen, not only for packed-bed reactor systems, but also for fluidized bed membrane reactors. Two-Fluid Model simulations of 3D cylindrical lab-scale fluidized beds with single and multiple vertically immersed cylindrical membranes with state-of-the-art hydrogen permeability were performed to quantify concentration polarization, to study the interaction between concentration polarization zones of multiple vertically immersed membranes and to link these findings to the bed hydrodynamics. Simulations of a fluidized bed consisting of 500 mu m particles using a H-2/N-2 mixture as fluidization gas with a single immersed membrane, show that reduced hydrogen concentrations prevail mostly within 1 cm from the membrane surface, and have disappeared beyond about 2 cm distance from the membrane surface. A 3D simulation was compared to a Cartesian 2D simulation that represents a slice of the 3D system, to assess the accuracy of 2D simulations. The 2D simulation did not fully capture the hydrodynamics and radial mass transfer effects of 3D cylindrical fluidized bed membrane reactors and overestimated the severity of concentration polarization and the formation of densified zones near the membrane surface. In particular, the hydrogen fluxes were determined at 0.217 mol/(m(2) s Pa-0.5) for the 3D case, and 0.133 mol/(m(2) s Pa-0.5) for the 2D case. The severity of densified zones is also affected by the particle size, because for smaller particles (250 mu m) the emulsion phase density near the membrane surface is higher than for systems with larger particles (500 mu m), which results in increased concentration polarization and a reduced extractive hydrogen flux. Therefore, employing relatively large particles of at least 500 mu m in fluidized beds with modern high-flux membranes is advised. In fluidized beds with multiple membranes, interaction between concentration polarization zones of each membrane was observed. The interaction becomes more significant at smaller inter-membrane distances, especially below 2 cm, and decreasing the bed diameter decreases the system performance even more due to hydrogen depletion. Vertically immersed membranes also affect the fluidized bed hydrodynamics by reducing bubble size and increasing the number of small bubbles. (C) 2019 Elsevier Ltd. All rights reserved.
引用
收藏
页码:299 / 318
页数:20
相关论文
共 50 条
  • [1] Mass transfer phenomena in fluidized beds with horizontally immersed membranes: A numerical investigation
    Voncken, R. J. W.
    Roghair, I
    Annaland, M. van Sint
    CHEMICAL ENGINEERING SCIENCE, 2018, 191 : 369 - 382
  • [2] Particle and bubble movements around tubes immersed in fluidized beds - a numerical study
    Rong, DG
    Mikami, T
    Horio, M
    CHEMICAL ENGINEERING SCIENCE, 1999, 54 (23) : 5737 - 5754
  • [3] The repeatability and uniformity of 3D fluidized beds
    Drake, Joshua B.
    Heindel, Theodore J.
    POWDER TECHNOLOGY, 2011, 213 (1-3) : 148 - 154
  • [4] Dynamic forces on an immersed cylindrical tube and analysis of particle interaction in 2D-gas fluidized beds
    Nagahashi, Yusumi
    Takeuchi, Hideki
    Grace, John R.
    Yoshioka, Daiki
    Tsuji, Takuya
    Tanaka, Toshitsugu
    ADVANCED POWDER TECHNOLOGY, 2018, 29 (12) : 3552 - 3560
  • [5] 3D particle-scale modeling of gas-solids flow and heat transfer in fluidized beds with an immersed tube
    Wahyudi, Hadi
    Chu, Kaiwei
    Yu, Aibing
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 97 : 521 - 537
  • [6] Experimental and numerical study of pseudo-2D circulating fluidized beds
    Klimanek, Adam
    Adamczyk, Wojciech
    Kallio, Sirpa
    Kozolub, Pawel
    Wecel, Gabriel
    Szlek, Andrzej
    PARTICUOLOGY, 2016, 29 : 48 - 59
  • [7] Discrete Bubble Model for Prediction of Bubble Behavior in 3D Fluidized Beds
    Movahedirad, Salman
    Ghafari, Mohsen
    Dehkordi, Asghar Molaei
    CHEMICAL ENGINEERING & TECHNOLOGY, 2012, 35 (05) : 929 - 936
  • [8] NUMERICAL STUDY OF BIOMASS GASIFICATION IN 3D FULL-LOOP CIRCULATING FLUIDIZED BEDS USING A EULERIAN MULTI-FLUID MODEL
    Wahyudi, Hadi
    Pinem, Mekro P.
    Rosyadi, Imron
    Chu, Kevin
    INTERNATIONAL JOURNAL OF TECHNOLOGY, 2018, 9 (02) : 229 - 237
  • [9] Coupling of CFD-DEM and reaction model for 3D fluidized beds
    Xie, Jun
    Zhong, Wenqi
    Shao, Yingjuan
    Li, Kaixi
    POWDER TECHNOLOGY, 2019, 353 : 72 - 83
  • [10] 3D Numerical Study of the Elastic and Strength Properties of Ceramics with Cylindrical Pores
    Smolin, A. Yu.
    Shalomeeva, A. A.
    Smolina, I. Yu.
    MECHANICS, RESOURCE AND DIAGNOSTICS OF MATERIALS AND STRUCTURES (MRDMS-2018), 2018, 2053