Impact of sol-gel precursor treatment with preheating temperature on properties of Cu2ZnSnS4 thin film and its photovoltaic solar cell

Cu2ZnSnS4 (CZTS) thin films are deposited by spin-coating deposition of sol-gel precursor followed by sulfurization under a sulfur-containing atmosphere. The impact of the sol-gel precursor treatment with preheating temperature on the properties of the CZTS thin films and its photovoltaic solar cell has been investigated. XRD analysis shows that all the deposited CZTS thin films exhibit kesterite crystal structure and own a best crystallinity when the sal-gel precursor is preheated at 300 degrees C. Raman analysis shows that ZnS as secondary phase has formed on surface of the deposited CZTS thin films and its contents decrease as the preheating temperature increases. Morphological analysis shows that the sol-gel precursor preheated at 300 degrees C can contribute to the improvement of grain size and crystallinity. Component analysis shows that the higher preheating temperature can contribute to the decrease of tin loss, ZnS content and carbon content but an increase of sodium content. Photoelectric properties analysis shows that the CZTS thin films as a function of preheating temperature at 300 degrees C have best values with a band gap of 1.45 eV, a resistivity of 8.42 tl cm, a carrier concentration of 1.26 x 10(17) cm(-3) and a mobility of 5.22 cm(2) V-1 s(-1), respectively. Finally, a solar cell device built with the best CZTS thin films exhibits a best efficiency of 1.45%. (C) 2015 Elsevier B.V. All rights reserved.