Core design of a high-temperature fast reactor cooled by supercritical light water

A high-temperature large fast reactor cooled by supercritical water (SCFR-H) is designed for assessing its technical feasibility and potential economical improvement. The coolant system is once-through, direct cycle where whole core coolant flows to the turbine. The goal is to achieve the high coolant outlet temperature over 500 degrees C. We study the reactors with blankets cooled by ascending and descending flow. SCFR-H adopts a radial heterogeneous core with zirconium-hydride layers between the driver core and the blankets for making coolant void reactivity negative. The coolant outlet temperature of the core with blankets cooled by ascending flow is low, 467 degrees C. The reasons are as follows: (I) the power swing due to the accumulation of fissile material in the inner blankets with burn-up, and (2) local power peak in the assemblies due to the zirconium-hydride layers. The difference in the outlet coolant temperature is more enhanced than the low temperature core where outlet temperature is approximately 400 degrees C. The reason is that the coolant temperature is more sensitive to the enthalpy change than near the pseudo critical temperature, 385 degrees C at 25 MPa. Thus, we design the core with blankets cooled by descending flow to obtain high coolant outlet temperature. The coolant outlet temperature becomes 537 degrees C, which is 70 degrees C higher than that of the core with ascending blanket flow. The thermal efficiency is improved from 43.2 to 44.6%. The coolant mass flow rate per electric power decreases by 14%. This will reduce the size of the balance of plant (BOP) system. The power of the reactor is high (1565 MWe) and the void reactivity is negative. (C) 1999 Elsevier Science Ltd. All rights reserved.