STRUCTURE AND CORROSION OF QUASICRYSTALLINE CAST Al-Co-Ni AND Al-Fe-Ni ALLOYS IN AQUEOUS NaCl SOLUTION

In this work the structure and corrosion behavior of quasicrystalline cast Al69Co21Ni10 and Al(72)Fe(15)Ni(3 )alloys in 5-% sodium chloride solution (pH 6.9-7.1) were investigated. The alloys were cooled at 5 K/s. The structure of the samples was studied by methods of quantitative metallography, X-ray analysis, and scanning electron microscopy. Corrosion properties were determined by potentiodynamic method. Stationary potential values were measured by means of long-term registration of (E,tau)-curves using III-50-1 potentiostat and Pi P-8 programmer with three-electrode electrolytic cell. A platinum electrode served as counter electrode and silver chloride - as reference electrode. The made investigations confirm the formation of stable quasicrystalline decagonal D-phase in the structure of Al69Co21Ni10 and Al72Fe15Ni13 alloys. In Al69Co21Ni10 alloy, at room temperature D-phase coexists with crystalline Al-9(Co,Ni)(2) phase, and in Al72Fe15Ni13 alloy - with Al5FeNi phase. Comparison of Vickers hardness of these phases exhibits the following sequence: H(D-AlCoNi)>H(D-AlFeNi)>H(Al5FeNi)>H(Al-9(Co,Ni-2). In 5 % sodium chloride solution, the investigated alloys corrode under electrochemical mechanisms with oxygen depolarization. Compared with Al72Fe15Ni3 alloy, Al69Co21Ni10 alloy has less negative value of stationary potential (-0,48 V and -0,40 V, respectively), and its electrochemical passivity region extends due to the inhibition of anodic processes. For both alloys, transition to passive state in the saline solution is observed. A corrosion current density, calculated from (E,lgi)-curve, for Al69Co21Ni10 alloy amounts to 0.12 mA/cm(2) and for Al72Fe15Ni3 alloy - to 0.14 mA/cm(2). After immersion in the saline solution for 8 days, pits are revealed on the surface of the alloys in areas, mainly where the phase boundaries and flaws are located. The number and size of pits are smaller on the surface of Al69Co21Ni10 alloy as compared with those on the surface of Al72Fe15Ni3 alloy. The lower corrosion resistance of Al72Fe15Ni3 alloy may be explained by the presence of ironcontaining phases in its structure. Based on obtained results, the Al69Co2Ni10 alloy has been recommended as coating material for rocket-and-space equipment working in marine climate.